Delphi TA1210 Steering Tie Rod End - Right Outer

Delphi TA1210 Front Right Outer Tie Rod End

Delphi TA1210 is a steering tie rod end built for OE-style replacement on the front right outer position. It is listed for Saab 9-3 and Saab 900 applications, with a bent steel design, pre-greased construction, and a coated finish for dependable service in steering linkage repair.

Key Features

• Part number: TA1210
• Steering tie rod end for the front right outer position
• Fits 1999-2003 Saab 9-3, right outer
• Fits 1994-1998 Saab 900, right outer
• Steel housing and steel tie rod construction
• Bent design with black coated finish
• Pre-greased and sealed with a dust boot included
• Mounting hardware included
• Non-adjustable, non-greaseable standard replacement

Detailed Description

Delphi TA1210 is engineered as a standard replacement steering tie rod end for Saab steering systems that use a front right outer configuration. Delphi applies OE-focused dimensional and material analysis to help maintain proper fit and steering geometry, while the part is tested across extreme temperature ranges and salt-spray exposure to reflect real-world undercar conditions. The result is a replacement tie rod end suited for restoring precise steering response on Saab 9-3 and Saab 900 models.

This part cross-references Mevotech Supreme MES3237 for the same application. If you are searching for a Delphi TA1210 tie rod end for Saab 9-3 or Saab 900, this listing matches the confirmed right outer fitment shown below.

Common Repair Uses

• Loose or wandering steering feel
• Clunking or play in the front steering linkage
• Uneven tire wear caused by worn steering components
• Restoring alignment stability after tie rod wear
• Replacing a damaged front right outer tie rod end

Installation Notes and Tips

Install Delphi TA1210 at the front right outer steering position only on the listed Saab applications. Verify thread direction, stud fit, and steering linkage condition before alignment. Because this is a non-adjustable replacement component, final toe settings should be checked after installation. For best results, inspect the mating inner tie rod and related steering hardware during service.

Quality Assurance

Delphi uses OE-based engineering practices for its aftermarket steering portfolio, with validation that includes temperature cycling below -40 degrees C and above 120 degrees C, plus extended salt-spray exposure. Part number TA1210 is built to support consistent replacement quality for steering service on confirmed Saab applications.