Delphi TA1217 Steering Tie Rod End - Right Outer

Delphi TA1217 Front Right Outer Tie Rod End

Delphi TA1217 is a standard replacement steering tie rod end for the front right outer position. It is built with OE-focused dimensional and material analysis to support proper steering geometry and consistent fit on the vehicle application.

Compatible with 1986-1990 Acura Legend, right outer. This Delphi TA1217 tie rod end is a direct-fit steering component for Acura Legend front-end service where outer tie rod wear affects alignment and steering response.

Key Features

• Front right outer steering tie rod end
• Female end 1 gender
• Dust boot included
• Mounting hardware included
• Standard replacement grade
• Grease fitting not included; non-greaseable design

OE-Style Steering Performance

Delphi applies OE engineering methods to its aftermarket steering portfolio, with testing that includes extreme temperature exposure below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray exposure. That validation helps support durability in demanding steering service conditions. For Acura Legend steering repair, TA1217 is built to match OE dimensions and materials for proper interface with the surrounding steering components.

This part cross-references Mevotech Supreme MES2811R for the same application.

Common Problems This Part Can Address

• Excessive play in the front right outer steering linkage
• Steering wander or loose on-center feel
• Uneven tire wear caused by worn steering joints
• Clunking or knocking from the front suspension during steering input
• Alignment instability after tie rod wear

Installation Notes

Inspect the inner tie rod, steering rack, and related front suspension parts before installation. After replacing the outer tie rod end on a 1986-1990 Acura Legend, perform a professional wheel alignment to restore toe settings and steering wheel position. Verify the dust boot seats correctly and confirm all fasteners are tightened to the vehicle service specification.

Quality Assurance

Delphi uses OE safety technology and extensive dimensional and material analysis to support aftermarket steering fitment and performance. The part is tested for temperature extremes and corrosion exposure to help maintain service reliability in steering applications.