Delphi TA1227 Steering Tie Rod End - Outer

Delphi TA1227 Outer Tie Rod End

Delphi TA1227 is a standard replacement outer steering tie rod end built for precise steering response and OE-style fitment. It is engineered for the 1984 Toyota Corolla and 1985-1989 Toyota MR2, making it a direct choice for Toyota Corolla outer tie rod end and Toyota MR2 outer tie rod end replacement needs.

Key Features

• Outer steering tie rod end for the steering linkage
• Pre-greased design with a sealed dust boot
• Steel housing and steel tie rod construction
• Coated gray finish for added surface protection
• Straight, non-adjustable design
• Female end 2 with threaded stud connection
• Mounting hardware included
• Delphi TA1227 part number for identification and ordering

Detailed Description

Delphi applies OE-focused dimensional and material analysis to its steering portfolio, and the TA1227 follows that approach with a standard replacement design for outer steering service. The part uses a steel housing, steel tie rod material, and a chloroprene rubber dust boot to help protect the joint from road contamination. It is pre-greased, greaseable no, and uses a straight configuration with clockwise thread direction at both ends. This part cross-references Beck/Arnley 101-3970 for the same application.

For Toyota Corolla and Toyota MR2 steering repair work, Delphi TA1227 supports accurate linkage restoration where worn outer tie rod ends can affect steering feel and alignment stability. The Delphi TA1227 is built for the outer position and matches the listed Toyota applications below.

Vehicle Fitment

• Fits 1984 Toyota Corolla, outer
• Fits 1985-1989 Toyota MR2, outer

What It Helps Fix

• Loose or vague steering response
• Clunking or play in the front steering linkage
• Uneven tire wear caused by worn steering components
• Steering wheel wander after suspension or alignment service
• Outer tie rod end wear at the Toyota Corolla or Toyota MR2 steering connection

Installation Notes

Replace the outer tie rod end during steering inspection when joint play, boot damage, or corrosion is present. After installation, perform a professional wheel alignment to restore toe settings and steering geometry. Verify thread direction, end dimensions, and outer position before installation on the vehicle.

Quality Assurance

Delphi subjects its steering components to extreme temperature and corrosion testing, including sub-zero and high-heat exposure and extended salt-spray evaluation. That testing, along with OE-based dimensional and material analysis, supports consistent fit and performance for the TA1227.