Delphi TA1356 Steering Tie Rod End - Inner
OE Quality 60-Day Returns
Delphi

Delphi TA1356 Steering Tie Rod End - Inner

Brand Delphi TA1356
Position Inner
Dust Boot Included No
End 1 Gender Male
Grease Fitting Included No
Greaseable No
Item Grade Standard Replacement
Mounting Hardware Included Yes
Position(s) Front Inner
Fits Volvo

Standard replacement. OE expertise applied to the aftermarket steering portfolio.

OE performance testing. Withstands extreme temperatures and 720 hours of salt spray.

Dimensional analysis. Helps ensure compatibility between OE and aftermarket parts.

Cross-references Beck/Arnley 101-4131, DNJ EV130 and Mevotech Supreme MEV130 for the same application. See all 8.

$31.55Free shipping
In stock · usually ships same day before 1pm CST
Step 1 — Confirm fitment
Free return shipping if it doesn't fit when you check fitment here first.

Select your vehicle to confirm fitment
Verify this part fits before purchasing β€” free returns if it doesn't
Step 2 — Quantity
Order total $31.55
Free shipping to the continental U.S.
Free returns within 60 days if it doesn't fit when fitment is verified.
Not what you need? See all Steering Tie Rod End options

Delphi TA1356 Front Inner Tie Rod End

Delphi TA1356 is a standard replacement steering tie rod end built for the front inner position. It is engineered with Delphi OE-level dimensional and material analysis to support proper steering geometry and consistent fitment on the intended application.

  • Front inner steering tie rod end
  • Male end 1 gender
  • Standard replacement grade
  • Mounting hardware included
  • No grease fitting and no dust boot included
  • Non-greaseable design

OE-Style Steering Replacement

Delphi applies OE safety and steering expertise to its aftermarket steering portfolio, and the TA1356 reflects that approach with testing for temperature extremes below -40 degrees C and above 120 degrees C, plus extended salt-spray exposure. This helps support durability in demanding road conditions while maintaining the dimensional accuracy needed for a proper steering connection. For buyers searching for a Delphi TA1356 steering tie rod end for front inner service, this part is a direct-fit style replacement for the specified application.

This part cross-references Beck/Arnley 101-4131 and Mevotech Supreme MEV130 for the same application.

Common Repair Uses

  • Loose or imprecise steering feel
  • Front-end play caused by worn steering linkage components
  • Uneven tire wear related to steering geometry wear
  • Clunking or knocking from the inner steering linkage area
  • Restoring steering response on vehicles using this front inner tie rod end

Installation Notes

Install the Delphi TA1356 at the front inner steering position only. Verify thread direction, steering rack interface, and alignment settings before and after installation. Because this design does not include a grease fitting or dust boot, inspect adjacent steering components and replace any worn hardware or seals as needed during service.

Quality Assurance

Delphi validates steering components through extreme-temperature and corrosion testing, along with dimensional and material analysis to support OE-style compatibility. Use this part number TA1356 when replacing the front inner tie rod end on the intended application, including searches for Delphi TA1356 and Delphi steering tie rod end replacement.

Related reading

This part fits 0 vehicles
Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.
YearMakeModelPositionNotes
Directly replaces or cross-references 8 part numbers
Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.
Beck/Arnley — 101-4131DNJ — EV130Mevotech Supreme — MEV13012283863530167AX07089IS130JAR196