Delphi TA1385 Steering Tie Rod End - Outer

Delphi TA1385 Front Outer Tie Rod End

Delphi TA1385 is a standard replacement steering tie rod end for the front outer position on select Mercedes-Benz models. It is built with OE-focused dimensional and material analysis to support proper fit and steering response on applications such as Mercedes-Benz S-Class and CL-Class vehicles.

Key Features

• Front outer steering tie rod end
• Male end 1 gender
• Dust boot included for joint protection
• Mounting hardware included
• Non-greaseable, maintenance-free design
• Standard replacement grade
• Delphi TA1385 part number for direct identification

Product Details

Delphi applies OE engineering experience to its aftermarket steering portfolio, and the TA1385 follows that approach with attention to fit, material selection, and dimensional accuracy. The component is tested across extreme temperature ranges and salt-spray exposure to evaluate durability in demanding steering environments. This part cross-references MOOG Chassis Products ES3574A for the same application.

Compatible With Mercedes-Benz CL500, CL600, S320, S420, S500, S600, S350, 300SD, 300SE, 400SEL, 500SEC, 500SEL, 600SEC, 600SEL, and 400SE in the front outer steering position. Delphi TA1385 is a direct-fit steering tie rod end for Mercedes-Benz S-Class and CL-Class front outer service work.

Common Repair Uses

• Loose or wandering steering feel
• Front-end steering play or clunking
• Uneven tire wear caused by worn steering linkage
• Restoring steering response after tie rod end wear
• Replacing a damaged front outer tie rod end on Mercedes-Benz models

Installation Notes

Install in the front outer steering position only. Verify thread direction, taper engagement, and alignment settings before returning the vehicle to service. Because this part includes a dust boot and mounting hardware, inspect the surrounding steering components, then perform a professional wheel alignment after installation. Confirm vehicle application by year, make, model, and position before ordering.

Quality Assurance

Delphi tests steering components for temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability and corrosion resistance. The TA1385 is backed by Delphi’s OE-focused manufacturing and validation process for aftermarket steering parts.