Delphi TA1535 Steering Tie Rod End - Outer

OE-Style Front Outer Tie Rod End

Delphi TA1535 is a standard replacement steering tie rod end for the front outer position. It is built with OE-focused dimensional and material analysis to support proper fit on Mitsubishi 3000GT, Dodge Stealth, and Mitsubishi Van applications.

• Front outer steering tie rod end
• Standard replacement part for OE-style service
• Pre-greased design with no grease fitting
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated gray finish
• Clockwise thread direction at both ends
• Mounting hardware included
• Non-adjustable, straight design

Built for OE Fit and Steering Response

Delphi TA1535 is engineered for front outer steering service where precise geometry and consistent joint movement matter. Delphi applies OE safety technology and aftermarket steering expertise to this tie rod end, with testing that includes extreme temperature exposure below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray exposure. The result is a replacement steering component intended to match OE dimensions and material characteristics for Mitsubishi 3000GT, Dodge Stealth, and Mitsubishi Van front outer applications. This part cross-references Beck/Arnley 101-4160 for the same application.

Vehicle Fitment

• Fits 1991-1999 Mitsubishi 3000GT, outer.
• Fits 1991-1996 Dodge Stealth, outer.
• Fits 1987-1990 Mitsubishi Van, outer.

Common Repair Uses

• Restores steering linkage movement when the original tie rod end is worn
• Addresses looseness or play in the front outer steering connection
• Helps correct steering wander caused by joint wear
• Supports replacement of a damaged dust boot or corroded steering end
• Helps resolve uneven steering feel from a deteriorated outer tie rod end

Installation Notes

Verify thread direction, thread diameter, and front outer position before installation. Delphi TA1535 is pre-greased and does not use a grease fitting, so no routine greasing is required. After installation, perform a professional alignment to confirm steering geometry and toe settings. Check the dust boot, mounting points, and adjacent steering components for wear before returning the vehicle to service.

Quality Assurance

Delphi uses OE-based dimensional and material analysis to improve part-to-part compatibility between original equipment and aftermarket steering components. The part is tested for temperature extremes and corrosion resistance to support dependable steering service in daily driving conditions.