Delphi TA1624 Steering Tie Rod End - Outer

Delphi TA1624 Front Outer Tie Rod End

Delphi TA1624 is a standard replacement steering tie rod end for the front outer position. It is built with OE-focused dimensional and material analysis to support proper fit and steering response on select Mazda applications, including Mazda Protege, MX-3, 323, and RX-7.

Key Features

• Front outer steering tie rod end
• Standard replacement design
• Pre-greased for initial service
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated black finish
• Mounting hardware included
• Straight type with threaded stud
• Clockwise thread direction on both ends
• Compatible with select Mazda steering applications

Detailed Description

Delphi TA1624 is engineered for steering service where accurate geometry and dependable joint movement matter. Delphi applies OE-level testing and material analysis to its aftermarket steering portfolio, including exposure to extreme temperatures and salt spray, to help verify durability and dimensional consistency. This tie rod end features a steel housing, plastic bearing material, chloroprene rubber dust boot, and a pre-greased, non-greaseable design for straightforward replacement service. The Delphi TA1624 is a direct-fit steering tie rod end for front outer use on 1990-1998 Mazda Protege, 1992-1996 Mazda MX-3, 1990-1995 Mazda 323, and 1993-1995 Mazda RX-7.

This part cross-references Beck/Arnley 101-4192 for the same application.

What It Helps Address

• Loose or imprecise steering feel at the front end
• Clunking or play from a worn outer tie rod joint
• Uneven tire wear caused by steering linkage wear
• Steering pull related to worn front suspension linkage
• Restoration of proper toe control after steering service

Installation Notes and Tips

Install on the front outer steering position only. Verify thread direction, thread diameter, and overall dimensions before installation, especially on Mazda Protege, MX-3, 323, and RX-7 applications. After replacement, perform a professional wheel alignment to restore steering geometry and tire wear characteristics. Inspect the mating steering components for wear before final assembly.

Quality Assurance

Delphi backs this steering component with OE-focused engineering practices, including dimensional and material validation and environmental testing for temperature and corrosion exposure. Part number TA1624 is built to meet standard replacement expectations for steering service.