Delphi TA1664 Steering Tie Rod End - Inner

Delphi TA1664 Front Inner Tie Rod End

Delphi TA1664 is a standard replacement steering tie rod end for front inner applications on select Acura and Honda models. Built with OE-focused dimensional and material analysis, it is made to match the original steering geometry and fitment requirements for Acura Integra, Acura EL, Honda Civic del Sol, and Honda Civic applications.

• Front inner steering tie rod end
• Adjustable straight design
• Steel housing and steel tie rod construction
• Pre-greased for initial service
• Coated black finish
• Male end 1 and male end 2 configuration
• Mounting hardware included
• Compatible with 1992-1995 Honda Civic, inner
• Compatible with 1993-1997 Honda Civic del Sol, inner
• Compatible with 1994-2001 Acura Integra, inner
• Compatible with 1997-2000 Acura EL, inner

This Delphi TA1664 steering tie rod end is engineered for front inner steering service where precise linkage movement and correct thread engagement matter. It features clockwise thread direction on both ends, a 12.0 mm end 1 thread diameter, a 14.0 mm end 2 thread diameter, and a 1.5 mm thread pitch at end 2. Delphi subjects its steering components to extreme temperature and corrosion testing, including sub-zero and high-heat exposure plus extended salt spray testing, to verify durability in demanding road conditions.

This part cross-references MOOG Chassis Products EV299 for the same application.

Common Steering Issues It Can Address

• Loose or vague steering feel from worn inner tie rod joints
• Uneven front tire wear caused by steering linkage play
• Clunking or knocking from the front steering system
• Incorrect toe settings that cannot be held during alignment
• Steering response delay on Acura Integra, Honda Civic del Sol, or Honda Civic front inner applications

Installation Notes and Tips

Verify thread direction, thread diameter, and center-to-end length before installation. This TA1664 is adjustable and pre-greased, and it includes mounting hardware; however, the dust boot is not included and the unit is not greaseable. After installation, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics.

Quality Assurance

Delphi applies OE-based engineering and extensive dimensional and material checks to its aftermarket steering portfolio. The TA1664 is tested for temperature extremes and corrosion resistance to support consistent steering performance in front inner applications.