Delphi TA1667 Steering Tie Rod End - Left Outer

Delphi TA1667 Left Outer Tie Rod End

Delphi TA1667 is a standard replacement steering tie rod end for the left outer position. It is built for Volkswagen Beetle, Golf, Golf City, Jetta, and Jetta City applications where precise steering linkage fitment matters.

• Left outer steering tie rod end
• Female end 1 gender
• Dust boot included
• Mounting hardware included
• Non-greaseable design with no grease fitting
• Standard replacement item grade

OE-Style Steering Replacement

Delphi applies OE-focused dimensional and material analysis to its aftermarket steering parts, helping support proper compatibility between the original and replacement component. The TA1667 is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability in demanding conditions. This Delphi TA1667 tie rod end is a direct-fit steering service part for Volkswagen Beetle and Volkswagen Jetta front-end steering repair work, as well as Golf and Golf City applications listed below.

This part cross-references MOOG Chassis Products ES3525 and Mevotech Supreme MES3525 for the same application.

Vehicle Fitment

• Fits 1999-2010 Volkswagen Beetle, left outer.
• Fits 2007-2010 Volkswagen Golf City, left outer; seventh and eighth digit of VIN is 9M or 1J.
• Fits 2000-2009 Volkswagen Jetta, left outer; 94mm length; seventh and eighth digit of VIN is 9M or 1J.
• Fits 2007-2009 Volkswagen Jetta City, left outer; seventh and eighth digit of VIN is 9M or 1J.
• Fits 2000-2006 Volkswagen Golf, left outer; seventh and eighth digit of VIN is 9M or 1J.
• Fits 1999 Volkswagen Golf, left outer; 3.7in from stud center to body end; seventh and eighth digit of VIN is 9M or 1J.
• Fits 1999 Volkswagen Jetta, left outer; 94mm length; from VIN # 9M-X-000 001.
• Fits 1998 Volkswagen Beetle, left outer; from VIN # W047125.

Installation Notes

Verify the left outer steering position and confirm VIN-specific notes before installation. Compare the original part length, end gender, and mounting points to the existing component on the Volkswagen Beetle, Golf, or Jetta platform. After replacement, perform a professional wheel alignment to restore steering geometry and tire wear characteristics.

Quality Assurance

Delphi uses OE-based engineering and validation methods for its steering portfolio, including dimensional and material checks plus environmental testing for heat and corrosion resistance. That process supports consistent fit and finish for the TA1667 steering tie rod end across the listed Volkswagen applications.