Delphi TA1675 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End

Delphi TA1675 is a front right steering tie rod end for select Ford Focus models with female threads. Built as a standard replacement part, it follows OE dimensional and material analysis to support proper steering geometry and consistent fit on the vehicle.

Fits 2000-2004 Ford Focus, right outer, with female threads.

Key Features

• Delphi steering tie rod end, part number TA1675
• Front right, right outer application for Ford Focus
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Mounting hardware included
• Clockwise thread direction on both ends
• Female end 2 thread design

Detailed Description

Delphi TA1675 is engineered for steering service on 2000-2004 Ford Focus models in the right outer position. It uses a bent design, a threaded stud, and a pre-greased, non-greaseable construction to simplify replacement while maintaining OE-style fit and function. The steel housing, steel tie rod, and chloroprene rubber dust boot are selected to handle everyday steering loads and help protect internal components from contamination.

Delphi applies OE-focused testing and dimensional analysis to its aftermarket steering portfolio, including exposure to extreme temperatures and salt spray testing. That approach helps ensure the part matches the intended OE application for the Ford Focus and supports accurate steering response after replacement. Delphi TA1675 also cross-references Mevotech Supreme MES3587 and MOOG ES3587 for the same application.

Common Problems This Part Can Address

• Loose or wandering steering feel
• Clunking or play from the front right steering linkage
• Uneven tire wear caused by worn tie rod components
• Steering wheel off-center after suspension wear
• Damage to the outer tie rod end from corrosion or boot failure

Installation Notes and Tips

Confirm the vehicle is a 2000-2004 Ford Focus with the right outer, female-threaded tie rod end before installation. After replacement, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Verify thread direction, stud fitment, and overall length against the removed part before final tightening.

Quality Assurance

Delphi backs this steering component with OE-based engineering practices, including dimensional and material analysis plus environmental testing for temperature and corrosion resistance. Those controls are used to support consistent aftermarket fit and performance for the Ford Focus application.