Delphi TA1748 Steering Tie Rod End - Outer

Delphi TA1748 Outer Tie Rod End

Delphi TA1748 is an outer steering tie rod end built for direct replacement service on select Saab 900 applications. It combines a straight, standard-replacement design with OE-focused dimensional and material analysis for consistent steering linkage fitment.

Fits 1979-1990 Saab 900, outer.

Key Features

• Outer steering tie rod end for Saab 900 applications
• Straight design with standard replacement grade
• High strength steel housing with coated finish
• Dust boot included for joint protection
• Mounting hardware included
• Clockwise thread direction on both ends
• End 1 thread diameter: 14.0 mm; End 2 thread diameter: 12.0 mm
• Delphi part number TA1748

Detailed Description

Delphi TA1748 is engineered as an outer steering tie rod end for the Saab 900 from 1979 through 1990. Delphi applies OE-level dimensional and material analysis to help ensure proper match-up between the aftermarket part and the original steering geometry. The housing is made from high strength steel, and the coated finish helps support long-term service in demanding undercar conditions. A chloroprene rubber dust boot is included to help protect the joint from contamination.

This Delphi tie rod end is a standard replacement part with a straight profile, non-adjustable construction, and threaded stud design. It cross-references Mevotech Supreme MES2132RL and Pure Energy T2132 for the same application. Use Delphi TA1748 when replacing a worn outer steering linkage component on a Saab 900 and when accurate thread sizing and OE-style fit are important.

Common Problems This Part Can Help Solve

• Loose or vague steering feel at the front end
• Clunking or knocking from worn steering linkage components
• Uneven tire wear caused by excessive toe movement
• Steering play from a deteriorated outer tie rod end
• Boot damage that exposes the joint to dirt and moisture

Installation Notes and Tips

Confirm thread direction, thread diameter, and position before installation. Delphi TA1748 is an outer tie rod end, so it should be installed in the correct steering linkage location on the Saab 900. After replacement, have the front-end alignment checked and adjusted to factory specifications. Inspect the mating steering components for wear before completing the repair.

Quality Assurance

Delphi subjects its steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. This part is backed by Delphi’s OE-focused engineering approach for aftermarket steering service.