Delphi TA1775 Steering Tie Rod End - Inner

Delphi TA1775 Front Inner Tie Rod End

Delphi TA1775 is a standard replacement steering tie rod end for the front inner position on select Mini Cooper models. It is built using Delphi OE-focused dimensional and material analysis to support proper steering geometry and consistent fitment on the vehicle.

• Front inner steering tie rod end
• Standard replacement grade
• Male end design
• End 1 thread diameter: 16.0 mm
• End 1 thread pitch: 1.50
• Length: 202.0
• Mounting hardware included
• No grease fitting, dust boot, or greaseable service point

Fitment Details

Compatible with 2002-2006 Mini Cooper, inner steering position. This Delphi TA1775 tie rod end is listed for the front inner location and matches the confirmed application data for Mini Cooper steering service.

This part cross-references MOOG Chassis Products (e.g., EV800092) for the same application.

What This Part Helps Address

• Loose or imprecise steering feel at the front inner linkage
• Clunking or play from worn steering connection points
• Uneven toe settings caused by worn tie rod components
• Steering response issues related to degraded inner tie rod joints
• Replacement needs during front-end steering repair on Mini Cooper models

Installation Notes

Verify thread diameter, thread pitch, and overall length before installation. Because this part is specified for the front inner position, confirm the steering side and alignment requirements during service. An alignment check is recommended after replacing steering linkage components on 2002-2006 Mini Cooper vehicles.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering portfolio and subjects parts to temperature extremes below -40 C and above 120 C, along with extended salt-spray exposure testing. Delphi TA1775 is built for standard replacement use with OE-focused dimensional and material validation.