Delphi TA1781 Steering Tie Rod End - Right Outer

Delphi TA1781 Steering Tie Rod End

Delphi TA1781 is a standard replacement steering tie rod end built for front right outer steering applications. It is listed for select Audi TT, Audi TT Quattro, and Volkswagen R32 models, with OE-focused construction that supports precise steering response and consistent fitment.

Key Features

• Fits front right outer steering positions on select Audi TT, Audi TT Quattro, and Volkswagen R32 applications
• Pre-greased design with a dust boot included
• Steel housing and steel tie rod construction with a coated black finish
• Clockwise thread direction on both ends
• Mounting hardware included
• OE-oriented dimensional and material analysis for application matching
• Tested for temperature extremes and salt-spray exposure during development

Detailed Description

Delphi TA1781 is a straight steering tie rod end engineered as a standard replacement for the front right outer position. It features a female end 2, threaded stud design, plastic bearing material, and chloroprene rubber dust boot material for a service-ready steering component. Delphi applies OE-based engineering methods to its aftermarket steering portfolio, including dimensional and material analysis to help maintain proper compatibility with the original steering setup. This part cross-references Beck/Arnley 101-5847 for the same application. For Audi TT, Audi TT Quattro, and Volkswagen R32 steering service, Delphi TA1781 provides a direct replacement option for the specified right outer position.

Common Repair Uses

• Restores worn steering linkage at the front right outer position
• Addresses looseness or play in the steering wheel caused by tie rod wear
• Helps correct uneven tire wear linked to steering end wear
• Replaces damaged dust boot or corroded steering end components
• Supports proper toe adjustment after steering service

Installation Notes and Tips

Install Delphi TA1781 only in the listed front right outer position for the confirmed vehicle applications. After replacement, perform a professional wheel alignment to verify toe settings and steering wheel centering. Compare the original part’s thread direction, thread diameter, and overall dimensions before installation to confirm match-up with the vehicle’s steering linkage.

Quality Assurance

Delphi uses OE-focused testing and material validation for its steering components, including exposure to extreme cold, high heat, and extended salt-spray testing. The brand’s aftermarket steering parts are developed from OE expertise to support consistent fit and performance in service applications.