Delphi TA1845 Steering Tie Rod End - Inner

OE-Style Inner Tie Rod End

Delphi TA1845 is a standard replacement steering tie rod end for the inner position on select Mercury Capri and Mazda 323 applications. Built with a high-strength steel housing, coated finish, and pre-greased construction, it is made for precise steering linkage service where OE-style fit and consistent movement matter.

Fits 1991-1994 Mercury Capri, inner, and fits 1986-1989 Mazda 323, inner. Delphi TA1845 is also a direct cross-reference for select aftermarket listings, including Mevotech Supreme MEV254.

Key Features

• Inner steering tie rod end for select Mercury Capri and Mazda 323 models
• Standard replacement design with adjustable construction
• High-strength steel housing and steel tie rod material
• Pre-greased for initial service readiness
• Coated black finish for added surface protection
• Male end configuration with clockwise thread direction on both ends
• Polyoxymethylene (POM) bearing material for controlled movement

Detailed Description

Delphi TA1845 is engineered as an OE-style steering tie rod end for the inner steering linkage. Delphi applies dimensional and material analysis to help maintain proper compatibility between the original part and the replacement component, while its steering portfolio is validated through extreme temperature and salt-spray exposure testing. The result is a replacement tie rod end built for demanding steering service on 1991-1994 Mercury Capri and 1986-1989 Mazda 323 vehicles.

This part number, TA1845, features a straight profile, standard grade construction, and an adjustable design to support steering linkage setup. It uses a 14.0 mm end 1 thread diameter and 12.0 mm end 2 thread diameter, with a 1.25 thread pitch on end 2. The part is supplied without a grease fitting or dust boot and is specified for the inner position.

What It Helps Address

• Loose or vague steering feel from worn inner tie rod components
• Steering play caused by worn linkage joints
• Uneven toe settings related to steering linkage wear
• Noisy or rough steering movement from degraded joint surfaces
• Replacement needs during front-end steering service on Mercury Capri and Mazda 323

Installation Notes and Tips

Confirm the inner position, thread direction, and thread diameters before installation. TA1845 is pre-greased and not greaseable, so no grease fitting is included. Because this tie rod end is adjustable, alignment should be checked after installation to restore proper steering geometry. Verify fitment against the vehicle application before service on 1991-1994 Mercury Capri or 1986-1989 Mazda 323 models.

Quality Assurance

Delphi uses OE-focused engineering and testing for its steering components, including temperature cycling below -40 degrees C and above 120 degrees C, plus 720 hours of salt-spray exposure. That validation supports consistent performance in steering applications such as Delphi TA1845.