Delphi TA1875 Steering Tie Rod End - Left Outer

Delphi TA1875 Front Left Outer Tie Rod End

Delphi TA1875 is a steering tie rod end built for the front left outer position on select BMW applications. It combines OE-based dimensional analysis with materials and testing intended to match factory fit and steering response on the 1997-2003 BMW 540i and 2000-2003 BMW M5.

Key Features

• Front left outer steering tie rod end for select BMW models
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction with coated finish
• Bent design with threaded stud type
• Mounting hardware included
• Black finish, standard replacement grade
• Delphi OE-focused engineering and dimensional analysis

Product Details

This Delphi steering tie rod end, part number TA1875, is engineered for precise replacement on BMW steering systems where correct geometry and joint feel matter. It is a non-adjustable, non-greaseable component with a pre-lubricated joint, chloroprene rubber dust boot, and female end configuration. Delphi subjects its steering components to extreme temperature and salt-spray testing and uses OE-level material and dimensional analysis to support consistent fitment on the BMW 540i and BMW M5.

This part cross-references MOOG Chassis Products ES80953 for the same application.

What It Helps Address

• Loose or vague steering feel at the front left outer linkage
• Clunking or play from a worn tie rod end joint
• Uneven tire wear caused by steering linkage wear
• Steering wander or poor on-center response
• Inspection failure from excessive steering component looseness

Installation Notes and Tips

• Fits 1997-2003 BMW 540i, left outer.
• Fits 2000-2003 BMW M5, left outer.
• Confirm thread direction, stud type, and end dimensions before installation.
• Have the front-end alignment checked after replacement.
• Inspect related steering and suspension parts for wear while the linkage is apart.

Quality Assurance

Delphi applies OE-focused testing and validation to its aftermarket steering portfolio, including exposure to extreme temperatures and extended salt-spray testing. Part number TA1875 is built as a standard replacement steering tie rod end for the specified BMW applications.