Delphi TA1906 Steering Tie Rod End - Outer

Delphi TA1906 Front Outer Tie Rod End

Delphi TA1906 is a standard replacement steering tie rod end for the front outer position. It is built for BMW steering applications that need precise linkage at the wheel end, including 2002-2010 BMW 745i, 745Li, 750i, 750Li, 760i, 760Li, 525i, 530i, 545i, 645Ci, 528i, 535i, 550i, 650i, M5, and M6.

For BMW 5 Series, 6 Series, 7 Series, M5, and M6 steering service, this part number TA1906 provides a direct-fit replacement path with OE-focused dimensional and material analysis.

Key Features

• Front outer steering tie rod end
• Female end 1 gender
• Dust boot included
• Mounting hardware included
• Non-greaseable design
• Standard replacement item grade
• Delphi part number TA1906

Detailed Description

Delphi TA1906 is engineered as a front outer steering tie rod end for BMW vehicles that require accurate steering linkage at the wheel side. Delphi applies OE-level dimensional and material analysis to support proper fit and consistent steering geometry, while its steering components are validated through temperature exposure below -40 degrees C and above 120 degrees C, plus extended salt-spray testing for corrosion resistance. This makes TA1906 a practical replacement for BMW 528i, 535i, 550i, 650i, M5, and related models where worn outer tie rod ends can affect steering response and alignment stability.

This part cross-references MOOG Chassis Products ES800478 and Beck/Arnley 101-5521 for the same application.

Vehicle Fitment

• Fits 2008-2010 BMW 528i, Outer
• Fits 2008-2010 BMW 535i, Outer
• Fits 2006-2010 BMW 550i, Outer
• Fits 2006-2010 BMW 650i, Outer
• Fits 2006-2010 BMW M5, Outer
• Fits 2006-2010 BMW M6, Outer
• Fits 2006-2008 BMW 750i, Outer
• Fits 2006-2008 BMW 750Li, Outer
• Fits 2003-2008 BMW 760Li, Outer
• Fits 2004-2007 BMW 525i, Outer
• Fits 2004-2007 BMW 530i, Outer
• Fits 2004-2006 BMW 760i, Outer
• Fits 2004-2005 BMW 545i, Outer
• Fits 2004-2005 BMW 645Ci, Outer
• Fits 2002-2005 BMW 745i, Outer
• Fits 2002-2005 BMW 745Li, Outer

Installation Notes and Tips

Confirm the front outer steering position before installation and compare the new tie rod end to the removed part for thread, taper, and length match. After replacement, perform a professional wheel alignment to restore steering wheel center and tire wear characteristics. Inspect adjacent steering components, including the inner tie rod and boots, while the system is apart.

Quality Assurance

Delphi uses OE-focused testing and engineering methods for its steering portfolio, including extreme temperature exposure and salt-spray validation. The TA1906 is built as a standard replacement steering component for BMW applications where fit and material consistency matter.