Delphi TA1915 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End

Delphi TA1915 is a front right outer steering tie rod end built for precise steering response and OE-style fitment. It serves as a direct replacement for a wide range of Audi and Volkswagen models, including Audi A3, Audi Q3, and Volkswagen Jetta applications.

Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility, while testing parts through extreme temperature swings and extended salt-spray exposure for demanding road conditions.

Key Features

• Steering tie rod end for the front right outer position
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint from contamination
• Steel housing and steel tie rod construction
• Coated gray finish for added corrosion resistance
• Includes mounting hardware
• Standard replacement grade for OE-style service
• Delphi part number TA1915

Detailed Description

Delphi TA1915 is a bent-style steering tie rod end with a threaded stud design, female end 2 connection, and clockwise thread direction at both ends. It is built with a chloroprene rubber dust boot, plastic bearing material, and a pre-greased joint to support smooth steering operation without routine greasing. This part cross-references MOOG Chassis Products ES80667 for the same application.

Compatible With 2006-2025 Audi A3, right outer; 2015-2025 Audi Q3, right outer; 2010-2024 Volkswagen Jetta, right outer; and other listed Audi and Volkswagen applications. Delphi TA1915 is also a strong match for drivers searching for a right outer tie rod end for Volkswagen GTI, Golf, Tiguan, Passat, and Audi S3 or RS3 service.

What It Helps Address

• Loose or vague steering feel
• Clunking or play in the front suspension steering linkage
• Uneven tire wear caused by worn steering components
• Steering wheel wander or poor directional stability
• Failed dust boot or contaminated tie rod joint

Installation Notes

Install on the front right outer steering position only, and verify vehicle-specific application before ordering. After replacement, a professional wheel alignment is recommended to restore proper steering geometry. Always confirm thread direction, stud size, and fitment against the vehicle’s application data for Audi A3, Audi Q3, Volkswagen Jetta, and related models.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its steering portfolio, including dimensional and material checks plus environmental testing at temperatures below -40 degrees C and above 120 degrees C. The part is also exposed to 720 hours of salt spray testing to evaluate corrosion resistance and long-term durability.