Delphi TA1958 Steering Tie Rod End - Right Inner

OE-Style Steering Tie Rod End

Delphi TA1958 is a standard replacement steering tie rod end for the right inner position on select Honda Fit applications. It is built with a steel housing and steel tie rod construction, a coated finish, and threaded male ends for a direct-fit steering service part.

Fits 2006-2008 Honda Fit, right inner with 16mm threads. Delphi applies OE-focused dimensional and material analysis to help maintain proper compatibility with the original steering setup, and this part is tested for temperature extremes and salt-spray exposure to support demanding road conditions.

Key Features

• Part number TA1958
• Steering tie rod end for the right inner position
• Standard replacement design
• Steel housing and steel tie rod material
• Coated black and gray finish
• Male threaded ends with clockwise thread direction
• Mounting hardware included
• No grease fitting and no dust boot

Detailed Description

Delphi TA1958 is a straight inner tie rod end engineered for steering service on 2006-2008 Honda Fit models with 16mm threads. The part uses a steel housing, plastic bearing material, and a coated exterior to support durability in everyday steering operation. Its fixed, non-adjustable design and standard replacement grade make it a direct service option for restoring steering linkage function on the specified Honda Fit right inner application. If you are sourcing a Honda Fit right inner tie rod end or searching for Delphi TA1958 for 2006-2008 Honda Fit steering repair, this part matches the listed fitment and thread specifications.

This part cross-references Honda 53010SAAJ01 for the same application.

What It Helps Address

• Excessive steering play at the inner tie rod location
• Loose or imprecise steering response
• Wear in the steering linkage on the right inner side
• Noise or movement from a worn steering connection
• Restoration of proper toe control after steering component wear

Installation Notes and Tips

Verify the right inner position, 16mm thread size, and clockwise thread direction before installation. Because this tie rod end is not adjustable and does not include a grease fitting or dust boot, inspect the surrounding steering components, alignment settings, and related hardware during service. After installation, a professional wheel alignment is recommended to confirm steering geometry on the Honda Fit.

Quality Assurance

Delphi uses OE-based dimensional and material analysis for aftermarket steering parts and subjects components to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That testing supports consistent fit and material durability for the TA1958 steering tie rod end.