Delphi TA1960 Steering Tie Rod End - Right Outer

Delphi TA1960 Front Right Outer Tie Rod End

Delphi TA1960 is a standard replacement steering tie rod end built for the front right outer position. It is engineered with OE-focused dimensional and material analysis to match the original steering geometry on select Mercedes-Benz applications, including E-Class and CLS models.

• Front right outer steering tie rod end
• Standard replacement part for select Mercedes-Benz vehicles
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated gray finish for added surface protection
• Mounting hardware included
• Bent style with threaded stud design

OE-Style Steering Replacement

Delphi applies OE safety and steering expertise to its aftermarket portfolio, and the TA1960 reflects that approach with careful fit and material control. The part is tested across extreme temperature ranges and salt-spray exposure to evaluate durability in demanding road conditions. For drivers servicing a Mercedes-Benz CLS550, CLS63 AMG, E320, E350, E550, E63 AMG, CLS500, CLS55 AMG, E500, or E55 AMG, this Delphi tie rod end supports precise front-end steering service on the right outer side. This part cross-references MOOG Chassis Products ES800387 for the same application.

Common Problems This Part Can Address

• Loose or vague steering feel at the front right outer linkage
• Uneven tire wear caused by worn steering joint components
• Clunking or play in the steering system during turns
• Restoring correct toe adjustment after tie rod wear
• Replacing a damaged or corroded outer tie rod end

Installation Notes

Verify right outer fitment before installation on 2003-2011 Mercedes-Benz E-Class and CLS applications. The TA1960 uses clockwise thread directions on both ends and a 14 mm thread diameter, so confirm thread match and steering linkage orientation before assembly. After installation, a professional wheel alignment is recommended to restore steering geometry and tire wear patterns.

Quality Assurance

Delphi validates steering components with dimensional and material analysis to support OE-level compatibility, and this part is exposed to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray testing. That testing focus helps confirm the durability expected from a steering tie rod end used in daily driving and service replacement.