Delphi TA1970 Steering Tie Rod End - Left Outer

Delphi TA1970 Front Left Outer Tie Rod End

Delphi TA1970 is a standard replacement steering tie rod end for the front left outer position on select Mazda 6 models. Built with OE-focused dimensional and material analysis, it is made to match the original steering geometry and fitment requirements for the application.

Fits 2003-2008 Mazda 6, left outer.

Key Features

• Front left outer steering tie rod end
• Standard replacement design for select Mazda 6 applications
• Pre-greased for initial service readiness
• Dust boot included to help protect the joint
• Coated steel housing and steel tie rod construction
• Bent style with threaded stud design
• Mounting hardware included
• Clockwise thread direction on both ends

Detailed Description

The Delphi TA1970 steering tie rod end is engineered for the front left outer position on 2003-2008 Mazda 6 vehicles. Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility with the original steering system, while the coated steel housing, steel tie rod, and chloroprene rubber dust boot support durable service in demanding road conditions. This part number, TA1970, is a direct-fit steering component for restoring steering linkage integrity on the specified Mazda 6 application.

This part cross-references MOOG Chassis Products ES800028 for the same application.

What It Helps Address

• Loose or imprecise steering response at the front left outer linkage
• Clunking or play caused by worn tie rod end joints
• Uneven tire wear related to steering linkage wear
• Steering pull or wandering from degraded front suspension geometry
• Boot damage that can expose the joint to contamination

Installation Notes and Tips

Verify the vehicle is a 2003-2008 Mazda 6 with the left outer steering position before installation. After replacing the tie rod end, perform a professional wheel alignment to restore correct toe settings and steering wheel centering. Inspect the mating steering components for wear before final assembly. Delphi TA1970 includes mounting hardware and arrives pre-greased, which supports installation on the specified application.

Quality Assurance

Delphi subjects its steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. The brand also uses OE-based analysis to support fitment consistency between original and aftermarket parts.