Delphi TA1972 Steering Tie Rod End - Inner

Delphi TA1972 Front Inner Tie Rod End

Delphi TA1972 is a standard replacement steering tie rod end for the front inner position on select Mazda 6 models. Built with OE-focused dimensional and material analysis, it is made to match the steering geometry and thread specifications needed for a precise repair.

Fits 2003-2008 Mazda 6, inner. This Delphi TA1972 tie rod end is pre-greased, coated, and supplied with mounting hardware for a straightforward steering service on the front inner linkage.

Key Features

• Part number: TA1972
• Front inner steering tie rod end
• Fits 2003-2008 Mazda 6, inner
• Adjustable straight design
• Pre-greased for service-ready installation
• Steel housing and steel tie rod construction
• Coated finish for added surface protection
• Male-to-male end configuration
• Clockwise thread direction on both ends
• Mounting hardware included

Detailed Description

Delphi TA1972 is engineered as an OE-style steering tie rod end for the front inner position on Mazda 6 vehicles from 2003 through 2008. It uses a straight, adjustable layout with an 18.0 mm thread diameter on one end and a 14.0 mm thread diameter on the other, helping maintain proper steering linkage fitment. The steel housing, steel tie rod material, and POM bearing material support consistent steering operation in demanding road conditions. Delphi validates its steering components through temperature and corrosion testing, including exposure to extreme cold, high heat, and extended salt spray, to help ensure dependable replacement performance. This part cross-references MOOG Chassis Products EV800029 for the same application.

Common Repair Symptoms

• Loose or vague steering feel
• Front-end play or wandering on the road
• Uneven tire wear caused by steering linkage wear
• Clunking or knocking from the front suspension area
• Improper toe setting after steering component wear

Installation Notes and Tips

Confirm the front inner position and verify thread direction, thread diameter, and overall length before installation. After replacing the tie rod end, perform a professional wheel alignment to restore steering geometry. Inspect the surrounding steering components, including the outer tie rod ends and boots, so worn parts are addressed during the same service.

Quality Assurance

Delphi applies OE-based engineering and validation to its aftermarket steering portfolio, with dimensional and material checks used to support fit and function. The TA1972 is built as a standard replacement part for Mazda 6 steering service.