Delphi TA1973 Steering Tie Rod End - Left Outer or Right Outer

OE-Style Steering Tie Rod End

Delphi TA1973 is a standard replacement steering tie rod end for front outer steering applications. It is built for vehicles that need precise steering response and dependable OE-style fitment, including select Scion tC and Toyota RAV4 applications.

• Standard replacement steering tie rod end
• End 1 gender: female
• Dust boot included for joint protection
• Mounting hardware included
• Grease fitting not included; non-greaseable design
• Position-specific fitment for front left outer or front right outer applications

Fitment Details

Compatible With 2005-2010 Scion tC, left outer. Compatible With 2001-2005 Toyota RAV4, right outer. Delphi TA1973 is also referenced by cross numbers such as MOOG ES3654 and Beck/Arnley 101-5053 for the same application.

Built Around OE Requirements

Delphi applies OE steering expertise to its aftermarket portfolio, with dimensional and material analysis used to support proper part matching. This tie rod end is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability in harsh conditions. For Scion tC and Toyota RAV4 steering service, TA1973 provides a direct replacement option for worn outer tie rod ends.

What It Helps Address

• Loose or vague steering feel at the front wheels
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering pull or poor alignment retention after component wear
• Restoring front left outer or front right outer steering linkage function

Installation Notes

Verify the vehicle position before installation, since this part is used in front left outer and front right outer applications depending on the vehicle. Always confirm thread direction, end gender, and application details against the vehicle’s steering layout before service. A professional alignment is recommended after replacement.

Quality Assurance

Delphi backs this steering component with OE-focused engineering, dimensional checks, and material analysis to support fit and performance consistency. The part is evaluated under temperature and corrosion testing to reflect demanding real-world steering conditions.