Delphi TA1980 Steering Tie Rod End - Inner

Delphi TA1980 Front Inner Tie Rod End

Delphi TA1980 is a steering tie rod end built for front inner applications on select Audi TT and Audi TT Quattro models. It combines OE-based dimensional analysis with materials chosen for consistent steering response and proper fitment.

Key Features

• Front inner steering tie rod end for select Audi TT and TT Quattro applications
• Adjustable straight design with male threaded ends
• Pre-greased and coated for service-ready installation
• Steel housing and steel tie rod construction
• Rubber dust boot material with POM bearing material
• Mounting hardware included
• End thread diameter: 16.0 mm; thread direction: clockwise on both ends

Detailed Description

Delphi TA1980 is engineered as a standard replacement steering tie rod end for the front inner position. Delphi applies OE-level dimensional and material analysis to help ensure proper compatibility between the replacement part and the original steering geometry. The part is tested for temperature extremes from below -40 degrees C to over 120 degrees C and exposed to 720 hours of salt spray to evaluate durability in demanding conditions. This makes TA1980 a practical choice for restoring steering linkage integrity on 2000-2006 Audi TT and 2000-2006 Audi TT Quattro models.

This part cross-references Mevotech Supreme MS70701 for the same application.

What It Helps Address

• Loose or vague steering feel at the front inner linkage
• Uneven tire wear caused by worn steering components
• Clunking or play in the steering system
• Restoring proper toe adjustment after tie rod wear
• Replacement of a damaged or corroded inner tie rod end

Installation Notes and Tips

Fits 2000-2006 Audi TT, inner. Fits 2000-2006 Audi TT Quattro, inner. Verify thread direction, thread diameter, and steering linkage measurements before installation. Because this is an adjustable straight tie rod end, a professional wheel alignment is recommended after replacement to set toe correctly and protect tire life. Delphi TA1980 is listed for the front inner position only.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its steering portfolio, including dimensional checks, material analysis, temperature cycling, and salt-spray exposure testing. Part number TA1980 is built to support consistent fit and steering performance in the specified applications.