Delphi TA2039 Steering Tie Rod End - Inner

OE-Style Steering Tie Rod End

Delphi TA2039 is a standard replacement steering tie rod end for front inner applications on select Honda, Acura, and Isuzu vehicles. It is built with OE-focused dimensional and material analysis to support proper steering geometry and consistent fitment.

Fits 1994-1997 Honda Accord, inner; fits 1995-1997 Honda Odyssey, inner; fits 1997-1999 Acura CL, inner; fits 1996-1999 Isuzu Oasis, inner.

Key Features

• Part number TA2039
• Front inner steering tie rod end
• Straight, adjustable design
• Steel housing and steel tie rod material
• Pre-greased for initial service
• Coated black finish for added surface protection
• Male end configuration with clockwise thread direction on both ends
• Mounting hardware included
• OE-focused fit and material analysis for application matching

Detailed Description

Delphi TA2039 is engineered as a standard replacement steering tie rod end for the front inner position. It uses a steel housing, steel tie rod material, and a coated finish, with a pre-greased design and no grease fitting for a simpler service setup. The straight, adjustable construction supports alignment correction during steering linkage service, while the 14.0 mm end 1 thread diameter, 12.0 mm end 2 thread diameter, and clockwise thread direction help maintain application-specific compatibility. Delphi applies OE-level dimensional and material analysis to help match the aftermarket part to the original steering component used on 1994-1997 Honda Accord, 1995-1997 Honda Odyssey, 1997-1999 Acura CL, and 1996-1999 Isuzu Oasis models. This part cross-references MOOG Chassis Products EV342 for the same application.

Common Problems This Part Can Address

• Excessive steering play from a worn inner tie rod end
• Uneven or unstable steering response
• Front-end alignment issues caused by linkage wear
• Clunking or looseness in the steering system
• Uneven tire wear related to steering geometry problems

Installation Notes and Tips

Confirm the vehicle is a front inner application before ordering. Compare thread direction, thread diameters, and overall length to the original part during inspection. After installation of TA2039, a professional wheel alignment is required to restore steering geometry. Inspect related steering components, including outer tie rod ends and boots, for wear before reassembly.

Quality Assurance

Delphi tests steering components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure and extended salt-spray testing. That validation supports OE-style durability for daily driving and long-term service.