Delphi TA2042 Steering Tie Rod End - Right Outer

Delphi TA2042 Front Right Outer Tie Rod End

Delphi TA2042 is a steering tie rod end for the front right outer position on select Saab applications. Built as a standard replacement, it combines OE-focused dimensional control with materials and sealing details that support precise steering response in Saab 9-3, Saab 9-3X, and Saab 9-5 service work.

Key Features

• Part number: TA2042
• Position: Front right outer
• Type: Bent steering tie rod end
• Pre-greased design with no grease fitting
• Dust boot included for joint protection
• Steel housing and steel tie rod construction
• Coated black finish
• Mounting hardware included
• Clockwise thread direction on both ends
• Standard replacement grade

Detailed Description

Delphi applies OE engineering practices to its aftermarket steering portfolio, using dimensional and material analysis to match the original part as closely as possible. TA2042 is built for the front right outer steering location and is listed for 2003-2011 Saab 9-3, 2010-2011 Saab 9-3X, and 2002-2009 Saab 9-5 applications. If you are searching for a Saab 9-3 front right outer tie rod end or a Saab 9-5 steering tie rod end replacement, Delphi TA2042 is the direct-fit service part to review.

The assembly uses a steel housing, steel tie rod, plastic bearing material, and a chloroprene rubber dust boot. It is pre-greased, non-adjustable, and non-greaseable, with a threaded stud design and included mounting hardware for service replacement. Delphi tests steering components across extreme temperature and salt-spray exposure conditions to verify durability under demanding road environments.

This part cross-references MOOG Chassis Products ES800410 and Beck/Arnley 101-5150 for the same application.

What It Helps Address

• Loose or wandering steering feel at the front right outer linkage
• Clunking or play from a worn tie rod end joint
• Uneven tire wear caused by steering linkage wear
• Steering pull or imprecise road tracking on Saab 9-3, Saab 9-3X, or Saab 9-5 models
• Inspection failure related to worn steering components

Installation Notes and Tips

• Verify vehicle year, model, and front right outer position before ordering.
• Inspect the mating steering linkage, boot condition, and alignment settings during replacement.
• Because the part is non-adjustable, final alignment should be checked after installation.
• Confirm thread direction and stud fitment against the original component before assembly.

Quality Assurance

Delphi uses OE-based testing and material validation for its steering parts, including temperature cycling below -40 degrees C and above 120 degrees C, plus extended salt-spray exposure. That validation supports consistent fit and durability for TA2042 in service on Saab steering applications.