Delphi TA2062 Steering Tie Rod End - Front Inner or Inner

Delphi TA2062 Front Inner Tie Rod End

Delphi TA2062 is a standard replacement steering tie rod end for front inner applications on select BMW models. It is built using Delphi OE-focused dimensional and material analysis to support proper fit and steering response on vehicles such as the BMW 335i, BMW 330i, and BMW X1.

Key Features

• Front inner steering tie rod end
• Male end 1 gender
• Standard replacement grade
• Mounting hardware included
• No grease fitting and no dust boot included
• Non-greaseable design
• Engineered with Delphi OE safety and performance testing standards
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray for corrosion resistance validation

Detailed Description

Delphi TA2062 is a front inner steering tie rod end made for BMW steering systems that use a TRW design. It is a direct-fit standard replacement for 2005-2006 BMW 330i inner, 2007-2011 BMW 335i inner, 2012 BMW 335i inner with old body style and TRW design, and 2013-2015 BMW X1 front inner TRW design applications. Delphi applies OE-level engineering methods to help ensure dimensional accuracy and material compatibility with the original steering setup. This part cross-references MOOG Chassis Products EV800564 for the same application.

What This Part Helps Address

• Loose or vague steering feel from worn inner tie rod components
• Steering play or wandering at the front end
• Uneven tire wear related to steering linkage wear
• Noisy or unstable steering response over bumps and road imperfections
• Restoring proper steering linkage geometry on BMW front inner applications

Installation Notes and Tips

Verify TRW design compatibility before installation and confirm the vehicle’s front inner steering layout matches the listed application. Inspect adjacent steering components, alignment settings, and fasteners during service. Because this part does not include a grease fitting or dust boot, replacement should be performed with attention to the condition of surrounding steering hardware and a post-installation alignment is recommended.

Quality Assurance

Delphi validates this steering component through extreme-temperature testing and extended salt-spray exposure, along with dimensional and material analysis to support OE-style fit and durability. The brand’s OE safety technology is used on millions of vehicles worldwide, and that engineering approach carries into the aftermarket steering portfolio.