Delphi TA2066 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End

Delphi TA2066 is a standard replacement steering tie rod end for the front right outer position. It is built for direct-fit service on select Chevrolet, Pontiac, and Suzuki applications, including Aveo, Aveo5, G3, G3 Wave, Swift+, Wave, and Wave5 models.

With pre-greased construction, a coated finish, a steel housing, and a dust boot included, this Delphi tie rod end is made for dependable steering linkage service. Delphi applies OE-level dimensional and material analysis to help maintain proper fit and steering response.

Key Features

• Part number TA2066
• Front right outer steering tie rod end
• Pre-greased and non-greaseable design
• Dust boot included with chloroprene rubber material
• Steel housing and steel tie rod construction
• Coated finish for added surface protection
• Mounting hardware included
• Clockwise thread direction on both ends
• Standard replacement item grade

Detailed Description

Delphi TA2066 is engineered as an OE-style steering tie rod end for vehicles that use a bent, threaded stud design in the front right outer steering position. It features a female end, plastic bearing material, and a 12.0 mm thread diameter with 1.5 thread pitch at end 2. The assembly is pre-greased and does not require a grease fitting, which supports low-maintenance service in the steering linkage.

This part cross-references MOOG Chassis Products ES800034 for the same application. Delphi TA2066 is a direct-fit option for 2004-2011 Chevrolet Aveo, 2006-2011 Chevrolet Aveo5, 2009-2010 Pontiac G3, 2009 Pontiac G3 Wave, 2004-2009 Suzuki Swift+, 2005-2008 Pontiac Wave, and 2005-2007 Pontiac Wave5, all in the right outer position.

Common Repair Uses

• Restoring steering precision after tie rod end wear
• Addressing looseness or play in the front right steering linkage
• Replacing a damaged dust boot or corroded steering joint
• Correcting uneven steering feel caused by worn outer tie rod components
• Servicing front-end steering wear on Chevrolet Aveo, Pontiac G3, and Suzuki Swift+ models

Installation Notes

Verify the front right outer position before installation and confirm thread direction, thread diameter, and stud style against the removed part. After installation, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Check adjacent steering components for wear before completing the repair.

Quality Assurance

Delphi tests steering components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure as well as extended salt-spray testing. That OE-focused validation helps support consistent fit and material performance for replacement steering service.