Delphi TA2087 Steering Tie Rod End - Outer

Delphi TA2087 Front Outer Tie Rod End

Delphi TA2087 is a standard replacement steering tie rod end for front outer applications on select Infiniti and Nissan vehicles. Built with OE-focused dimensional and material analysis, it is engineered for consistent steering response and proper fitment on applications such as the Nissan Frontier, Pathfinder, Xterra, and Infiniti Q45.

Key Features

• Front outer steering tie rod end
• Delphi TA2087 standard replacement part
• Steel housing and steel tie rod construction
• Pre-greased design with no grease fitting
• Dust boot included with chloroprene rubber (CR) boot material
• Coated black finish for added surface protection
• Clockwise thread direction at both ends
• Mounting hardware included
• Non-adjustable, straight design

Detailed Description

Delphi TA2087 is a steering tie rod end designed for the front outer position and built to match OE-style dimensions for accurate steering linkage service. The part uses a steel housing, steel tie rod, and plastic bearing material, with a threaded stud and female end 2 configuration. Delphi subjects its steering components to extreme temperature cycling and extended salt-spray exposure, then verifies dimensional and material compatibility to help ensure the aftermarket part aligns with the original application. This part cross-references MOOG Chassis Products ES3466 for the same application.

Compatible With select Infiniti and Nissan models, including Fits 1997-2006 Infiniti Q45, Outer; Fits 2005-2006 Nissan X-Trail, Outer; Fits 2003-2004 Infiniti M45, Outer; Fits 1998-2004 Nissan Frontier, Outer; Fits 1996-2004 Nissan Pathfinder, Outer; Fits 2004 Nissan Pathfinder Armada, Outer; Fits 2000-2004 Nissan Xterra, Outer; Fits 1997-2003 Infiniti QX4, Outer; and Fits 1993-1997 Infiniti J30, Outer. Delphi TA2087 is a direct-fit steering service part for these front outer applications.

Common Steering Issues This Part May Address

• Excessive steering play or looseness at the front outer linkage
• Clunking or knocking from worn tie rod end joints
• Uneven tire wear caused by steering linkage wear
• Poor steering response or wandering at the wheel
• Boot damage or contamination at the steering joint

Installation Notes and Tips

Inspect the steering linkage, inner tie rod, and alignment settings before installation. Because this is a front outer tie rod end, a professional wheel alignment is recommended after replacement to restore proper toe settings and steering feel. Verify thread direction, end dimensions, and vehicle application before service. Delphi TA2087 includes mounting hardware and a dust boot, and it is pre-greased for installation.

Quality Assurance

Delphi applies OE-level engineering practices to its aftermarket steering portfolio, including temperature testing below -40 degrees C and above 120 degrees C, plus 720 hours of salt-spray exposure. These validation steps support durability and fit consistency for Infiniti and Nissan steering service applications.