Delphi TA2088 Steering Tie Rod End - Inner

Delphi TA2088 Front Inner Tie Rod End

Delphi TA2088 is a steering tie rod end built as a standard replacement for the front inner steering position. It features a straight steel construction, coated finish, pre-greased design, and included mounting hardware for service-ready replacement on select Nissan X-Trail applications.

Fits 2005-2006 Nissan X-Trail, inner, male threads. This Delphi TA2088 tie rod end is also referenced by Beck/Arnley 102-5534 for the same application.

Key Features

• Front inner steering tie rod end
• Straight design with male threads on both ends
• Steel housing and steel tie rod material
• Coated black finish for added surface protection
• Pre-greased for initial service use
• Adjustable construction for steering linkage setup
• Mounting hardware included
• Standard replacement grade

Product Details

Delphi applies OE-focused dimensional and material analysis to its aftermarket steering parts to help maintain proper fit and steering geometry. TA2088 is engineered with a steel housing, polyoxymethylene bearing material, and a straight adjustable layout for the front inner steering linkage. The part is built to handle demanding temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing.

For vehicle-specific search intent, this part is a direct-fit steering tie rod end for 2005-2006 Nissan X-Trail inner steering service. Use Delphi TA2088 when replacing worn front inner steering components on the Nissan X-Trail.

Common Problems This Part Can Address

• Excessive steering play or looseness
• Clunking or knocking from the front steering linkage
• Uneven tire wear caused by worn steering components
• Steering wheel wander or poor directional stability
• Loose inner tie rod movement during inspection

Installation Notes

Verify thread direction, thread diameter, and overall length before installation. TA2088 uses clockwise thread direction on both ends, with a 16.0 mm thread diameter on end 1 and a 14.0 mm thread diameter on end 2. Because this is a front inner steering component, a professional alignment is recommended after installation to restore correct toe settings and steering response.

Quality Assurance

Delphi tests steering components for OE-level performance under temperature extremes and corrosion exposure, and its OE-based engineering approach supports dimensional compatibility with the intended application. The TA2088 is built as a standard replacement part for select Nissan X-Trail models.