Delphi TA2094 Steering Tie Rod End - Left Inner

Delphi TA2094 Front Left Inner Tie Rod End

Delphi TA2094 is a standard replacement steering tie rod end built for the front left inner position. It is engineered with Delphi OE-focused dimensional and material analysis to help maintain proper steering geometry on select Mazda Protege and Protege5 applications.

Compatible with 1999-2003 Mazda Protege and 2002-2003 Mazda Protege5, this Delphi tie rod end is a direct-fit steering service part for vehicles with male-thread inner left steering connections.

Key Features

• Front left inner steering tie rod end
• Male end 1 gender for the listed applications
• Standard replacement grade
• Mounting hardware included
• No grease fitting and no dust boot included
• Non-greaseable design
• OE-focused fit and material analysis for application matching
• Part number TA2094

Detailed Description

Delphi TA2094 is designed for steering service on the front left inner position of select Mazda Protege and Mazda Protege5 models. Delphi applies OE-level engineering practices to its aftermarket steering portfolio, including dimensional and material analysis to support proper compatibility with the original steering layout. The part is tested across extreme temperature ranges and salt-spray exposure to help validate durability in demanding road conditions. If you are replacing a worn inner tie rod end on a 1999-2003 Mazda Protege or a 2002-2003 Mazda Protege5, TA2094 provides a direct replacement option for the specified male-thread application.

This part cross-references Beck/Arnley 101-5227 for the same application.

What It Helps Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise front-end steering response
• Uneven tire wear caused by steering linkage wear
• Clunking or knocking from the front steering system
• Alignment issues related to steering linkage wear

Installation Notes and Tips

Install TA2094 only on the listed front left inner position for the confirmed Mazda applications. Verify male-thread configuration, steering linkage condition, and alignment settings before and after replacement. Because no grease fitting is included and the design is non-greaseable, routine lubrication service is not part of installation. Mounting hardware is included, but always inspect adjacent steering components for wear before completing the repair.

Quality Assurance

Delphi validates its steering components through OE-oriented testing, including exposure to temperatures below -40 degrees C and above 120 degrees C, plus extended salt-spray testing. That testing approach supports consistent performance for the Delphi TA2094 in everyday steering service.