Delphi TA2112 Steering Tie Rod End - Inner

Delphi TA2112 Front Inner Tie Rod End

Delphi TA2112 is a standard replacement steering tie rod end for front inner applications on select Acura and Honda models. It combines a steel housing, coated finish, and pre-greased construction to support precise steering linkage service on the Acura CL, Acura TL, and Honda Accord.

Key Features

• Front inner steering tie rod end for select Acura and Honda applications
• Steel housing with coated finish for corrosion resistance
• Pre-greased design; grease fitting not included
• Adjustable straight style with male/male ends
• Mounting hardware included
• Polyoxymethilen (POM) bearing material for consistent movement
• End 1 thread diameter: 16.0 mm; End 2 thread diameter: 14.0 mm
• End 2 thread pitch: 1.5; clockwise thread direction on both ends

Detailed Description

Delphi TA2112 is built as a standard replacement steering tie rod end for the front inner position. It is engineered with OE-focused dimensional and material analysis to help maintain proper fit and steering geometry across the intended applications. Delphi also validates steering components under extreme temperature and salt-spray exposure conditions, reflecting the brand’s OE-oriented approach to aftermarket steering parts. This part cross-references MOOG Chassis Products EV415 for the same application.

Compatible With 2001-2003 Acura CL, inner; 1999-2003 Acura TL, inner; and 1998-2002 Honda Accord, inner. If you are servicing a Honda Accord front inner tie rod end or replacing steering linkage parts on an Acura TL or Acura CL, Delphi TA2112 provides a direct replacement option for the listed fitments.

What It Helps Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise steering response
• Uneven front tire wear caused by steering linkage wear
• Clunking or knocking from the front steering system
• Alignment issues after steering component wear

Installation Notes and Tips

Install Delphi TA2112 at the front inner steering position only for the listed vehicles. Verify thread direction, thread diameter, and overall length before installation, and perform a wheel alignment after replacement. Because this part is pre-greased and does not include a grease fitting or dust boot, inspect adjacent steering components and boots during service.

Quality Assurance

Delphi applies OE-level engineering practices to its steering portfolio, including dimensional and material checks for fit consistency and durability testing across temperature and corrosion exposure. Part number TA2112 is built to meet standard replacement needs for the specified Acura and Honda applications.