Delphi TA2175 Steering Tie Rod End - Outer or Right Outer

Delphi TA2175 Outer Tie Rod End

Delphi TA2175 is a steering tie rod end built for outer steering linkage service on select Chrysler and Dodge applications. It combines OE-focused dimensional analysis with a coated high-strength steel housing, pre-greased construction, and a supplied dust boot for dependable steering response.

Compatible With Chrysler Fifth Avenue, Chrysler New Yorker, Chrysler LeBaron, Chrysler Town & Country, Dodge Aspen, Dodge Monaco, Chrysler Newport, and Chrysler 300 applications that use the listed outer steering position and rod specifications.

Key Features

• Part number: TA2175
• Outer steering tie rod end for right-side outer applications where specified by vehicle fitment
• Pre-greased with a grease fitting included for serviceability
• Dust boot included to help protect the joint from road contamination
• High-strength steel housing with coated finish
• Threaded stud design with male ends and clockwise thread direction
• Standard replacement grade for steering linkage service
• Mounting hardware included where required by the part design

Detailed Description

Delphi TA2175 is engineered as a standard replacement steering tie rod end for outer steering applications on classic Chrysler and Dodge platforms. Delphi applies OE dimensional and material analysis to help ensure proper fit and consistent steering linkage geometry, while the part is tested for temperature extremes and salt-spray exposure to support durability in demanding road conditions. This tie rod end uses a steel tie rod material, plastic bearing material, and chloroprene rubber dust boot material for a service-ready steering component.

This part cross-references MOOG Chassis Products ES352R and Mevotech Supreme MES352R for the same application. Delphi TA2175 is a direct-fit steering service part for many Chrysler New Yorker and Chrysler 300 applications, as well as select Dodge Monaco and Dodge Aspen models with the specified outer rod configuration.

Common Issues This Part Can Help Address

• Excessive steering play or looseness at the outer linkage
• Clunking or knocking from worn steering joints
• Uneven tire wear caused by steering end wear
• Imprecise steering feel during lane changes or turns
• Boot damage that exposes the joint to dirt and moisture

Installation Notes and Tips

Verify the vehicle’s outer tie rod specification, including rod diameter, thread size, and position, before installation. This part is not adjustable, so alignment should be checked after replacement to confirm steering wheel centering and toe settings. For the listed Chrysler and Dodge fitments, confirm the application notes in the vehicle catalog, especially where 11/16-inch diameter rod requirements are shown.

Quality Assurance

Delphi backs this steering component with OE-oriented engineering and validation. The part is evaluated for extreme temperature exposure and extended salt-spray resistance, and Delphi’s dimensional and material analysis is used to support OE-to-aftermarket compatibility.