Delphi TA2187 Steering Tie Rod End - Outer

OE-Style Outer Tie Rod End for Nissan Steering

The Delphi TA2187 is a standard replacement outer steering tie rod end built for Nissan applications that need precise steering linkage support. It combines OE-focused dimensional analysis with high-strength steel construction to help maintain proper steering response on compatible Nissan Pickup, Pathfinder, and D21 models.

Key Features

• Part number TA2187 outer steering tie rod end
• Fits outer steering position on select Nissan Pickup, Pathfinder, and D21 applications
• High-strength steel housing with coated finish
• Dust boot included to help protect the joint from contamination
• Male/male straight design with threaded stud construction
• Non-adjustable standard replacement design
• Delphi OE-based dimensional and material analysis for fit consistency

Product Details

Delphi TA2187 is engineered as a standard replacement steering tie rod end for the outer position. It features a straight, non-adjustable layout with a high-strength steel housing, steel tie rod material, plastic bearing material, and a chloroprene rubber dust boot. The coated black finish helps support long-term durability in demanding steering environments. This part cross-references MOOG Chassis Products ES3375 for the same application.

Compatible With 1995-1997 Nissan Pickup, outer; 1995 Nissan Pathfinder, outer right hand threads; 1994 Nissan D21, outer; and 1993-1994 Nissan Pathfinder, outer. The TA2187 is a direct-fit steering service part for vehicles that require an outer tie rod end with the listed thread specifications and mounting geometry.

Common Steering Issues This Part Can Address

• Loose or vague steering feel from worn outer tie rod joints
• Uneven front tire wear caused by steering linkage play
• Clunking or knocking noises from the front steering system
• Steering wheel wander or reduced directional stability
• Excessive movement at the outer tie rod connection point

Installation Notes and Tips

Verify thread direction, thread diameter, and position before installation. TA2187 uses clockwise thread direction on both ends, with a 16.0 mm thread diameter on end 1 and 12.0 mm on end 2. Because this is an outer steering component, a professional alignment is recommended after replacement to restore correct toe settings and steering geometry.

Quality Assurance

Delphi applies OE-focused testing and material validation to its steering portfolio. This part is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray testing to help verify durability in harsh conditions. Delphi also uses dimensional and material analysis to support OE-to-aftermarket compatibility for the TA2187.