Delphi TA2195 Steering Tie Rod End - At Pitman Arm

Delphi TA2195 Steering Tie Rod End

Delphi TA2195 is a straight steering tie rod end built for OE-style replacement performance at the pitman arm. It is pre-greased, includes a dust boot, and uses a coated steel housing and steel tie rod construction for dependable steering linkage service on select Dodge Ram trucks.

Compatible with 2000-2002 Dodge Ram 2500, At Pitman Arm; 2000-2002 Dodge Ram 3500, At Pitman Arm; and 2000-2001 Dodge Ram 1500, At Pitman Arm. This Delphi TA2195 tie rod end is a direct-fit standard replacement for steering repair work where precise thread direction and dimensional match matter.

Key Features

• Steering tie rod end for pitman arm applications
• Straight design with male/male end configuration
• Pre-greased with dust boot included
• Coated finish with steel housing and steel tie rod material
• Mounting hardware included
• Standard replacement grade
• Clockwise thread direction on both ends

Detailed Description

Delphi TA2195 is engineered for steering linkage service on Dodge Ram 1500, Ram 2500, and Ram 3500 applications listed above. The part uses OE-focused dimensional and material analysis to support proper fit at the pitman arm, while the steel housing, chloroprene rubber dust boot, and pre-greased construction help support long-term steering system service. Delphi also validates its steering components through temperature and corrosion exposure testing, including sub-zero and high-heat conditions plus extended salt spray exposure.

This part cross-references MOOG Chassis Products ES3527 and Mevotech Supreme MES3527 for the same application. The Delphi TA2195 is a practical choice when replacing a worn steering tie rod end on a Dodge Ram 1500, Ram 2500, or Ram 3500 with the specified pitman arm fitment.

Common Problems This Part Can Address

• Steering play or looseness at the pitman arm connection
• Clunking or knocking from worn steering linkage components
• Uneven steering response caused by worn tie rod end joints
• Boot damage that allows contamination into the joint
• Corrosion-related wear in exposed steering hardware

Installation Notes and Tips

Verify thread direction, stud type, and pitman arm fitment before installation. This part is non-adjustable and uses clockwise threads on both ends, so confirm the steering linkage configuration matches the vehicle application. After installation, inspect alignment and steering centering, and check all related linkage components for wear before returning the vehicle to service.

Quality Assurance

Delphi applies OE-based engineering and validation to its aftermarket steering portfolio. TA2195 is built to meet dimensional and material requirements for the listed Dodge Ram applications and is tested for temperature extremes and corrosion resistance to support consistent steering performance.