Delphi TA2211 Steering Tie Rod End - Inner

Delphi TA2211 Inner Steering Tie Rod End

Delphi TA2211 is a standard replacement inner steering tie rod end built for precise steering linkage service on select Ford, Mazda, and Mercury applications. It uses OE-focused dimensional and material analysis to support proper fit and consistent steering response on vehicles such as the Ford Ranger, Mazda B3000, and Mazda B4000.

Key Features

• Inner steering tie rod end for steering gear and related components
• Adjustable straight design for application-specific alignment setup
• Pre-greased construction with no grease fitting required
• Steel housing and steel tie rod material with coated finish
• Male end 1 and male end 2 configuration
• Mounting hardware included
• Clockwise thread direction on both ends
• Delphi part number TA2211

Detailed Description

Delphi TA2211 is engineered as an inner steering tie rod end for direct replacement service where accurate steering linkage geometry matters. The part features a straight, adjustable layout with a 16.0 mm end 1 thread diameter and 14.0 mm end 2 thread diameter, plus a 233.0 mm stud-center-to-end length for application-specific steering fitment. Its steel housing, steel tie rod, and coated finish support durable service, while the pre-greased design and POM bearing material help reduce maintenance requirements. Delphi TA2211 is a practical choice for restoring steering feel on Ford Ranger, Mazda B2300, Mazda B3000, Mazda B4000, Mazda B2500, Explorer, and Mountaineer applications listed below.

This part cross-references MOOG Chassis Products EV317 for the same application.

Vehicle Fitment

• Fits 2001-2010 Mazda B2300, Inner
• Fits 1998-2010 Mazda B4000, Inner
• Fits 1998-2008 Mazda B3000, Inner
• Fits 1998-2004 Ford Ranger, Inner
• Fits 1995-2001 Ford Explorer, Inner
• Fits 1998-2001 Mazda B2500, Inner
• Fits 1997-2001 Mercury Mountaineer, Inner

Common Repair Symptoms

• Loose or wandering steering feel
• Excessive play in the steering linkage
• Uneven tire wear caused by worn steering components
• Clunking or knocking from the front steering system
• Alignment issues after tie rod wear

Installation Notes

Verify inner tie rod length, thread direction, and thread diameters before installation. Because TA2211 is adjustable, final alignment should be checked after installation to confirm steering wheel center and toe settings. Inspect related steering components for wear before completing the repair on Ford Ranger, Mazda B3000, or Explorer applications.

Quality Assurance

Delphi applies OE-focused testing and dimensional analysis to its steering portfolio. This part is evaluated for extreme temperature exposure and salt-spray resistance to support dependable aftermarket replacement performance.