Delphi TA2229 Steering Tie Rod End - Left Outer

Delphi TA2229 Left Outer Tie Rod End

Delphi TA2229 is a standard replacement steering tie rod end for the left outer position. It is built with a high-strength steel housing, a coated finish, and pre-greased construction for service-ready installation on select Ford truck applications.

Key Features

• Fits the left outer steering position
• Compatible with 1973-1979 Ford F-250, left outer, with 6200 lb GVW
• Compatible with 1975-1979 Ford F-350, left outer
• High-strength steel housing with coated finish
• Pre-greased design with grease fitting included
• Dust boot included for added joint protection
• Mounting hardware included
• Non-adjustable, standard replacement design
• Male threaded ends with threaded stud construction

Detailed Description

The Delphi TA2229 steering tie rod end is engineered for the left outer steering location on select Ford F-250 and Ford F-350 trucks. Delphi applies OE-level dimensional and material analysis to help maintain proper fit between the replacement part and the original steering geometry. The part number TA2229 is built with a steel tie rod body, plastic bearing material, and a chloroprene rubber dust boot to support durable steering service in demanding conditions.

Delphi tests steering components across extreme temperature ranges and extended salt-spray exposure to evaluate corrosion resistance and performance consistency. This tie rod end uses counterclockwise and clockwise thread directions at the ends, 18 threads per inch, and a bent profile for the specified application. If you are searching for a Ford F-250 left outer tie rod end or a Ford F-350 steering tie rod end, TA2229 is a direct-fit option for the listed vehicles.

This part cross-references Mevotech Supreme MDS794 and MOOG DS794 for the same application.

Common Issues This Part Can Address

• Excessive steering play at the front axle
• Loose or wandering steering feel
• Uneven front tire wear caused by worn steering linkage
• Clunking or knocking from the steering system
• Visible wear, looseness, or boot damage at the outer tie rod end

Installation Notes and Tips

Verify left outer position, thread direction, and vehicle GVW before installation. After replacement, have the front end inspected and the alignment checked to confirm steering geometry is within specification. Inspect adjacent steering linkage components for wear so the new tie rod end is not installed into a worn system.

Quality Assurance

Delphi uses OE-focused engineering and material validation for its steering portfolio. The TA2229 is evaluated for temperature extremes and corrosion exposure to support consistent performance in service.