Delphi TA2236 Steering Tie Rod End - At Pitman Arm or Left Outer

Delphi TA2236 Steering Tie Rod End

Delphi TA2236 is a straight steering tie rod end built for OE-style replacement on select Jeep steering systems. It is pre-greased, greaseable, and supplied with a dust boot and mounting hardware for service work on the front steering linkage.

• Steering tie rod end for left outer or pitman arm positions, depending on application
• Straight design with male/male ends
• Pre-greased with grease fitting included
• Dust boot included for joint protection
• High strength steel housing with coated finish
• Standard replacement grade
• Thread details: 0.688 in. end 1 diameter, 0.5 in. end 2 diameter
• Clockwise thread direction on both ends

OE-Style Steering Replacement

Delphi applies OE engineering and dimensional analysis to its aftermarket steering parts so the replacement matches the original part’s fit and material profile more closely. TA2236 is built with a steel tie rod body, high strength steel housing, and a chloroprene rubber dust boot to support long-term steering service in demanding conditions. This part cross-references MOOG Chassis Products ES3094L and Mevotech Supreme MES3094L for the same application.

Compatible With 1997-2006 Jeep TJ, left outer; 1997-2006 Jeep Wrangler, left outer; 1991-2001 Jeep Cherokee, left outer; 1993-1998 Jeep Grand Cherokee, left outer; 1991-1995 Jeep Wrangler, at pitman arm; and 1991-1992 Jeep Comanche, left outer. If you are replacing worn steering linkage on a Jeep Wrangler, Cherokee, or Grand Cherokee, Delphi TA2236 provides a direct-fit service part for the listed positions.

Common Steering Issues Addressed

• Loose or wandering steering feel
• Excessive play at the steering linkage
• Clunking or knocking from worn tie rod joints
• Uneven tire wear caused by steering wear
• Damaged dust boot or contaminated joint grease

Installation Notes

Verify the vehicle position before ordering, since TA2236 is listed for left outer and at pitman arm applications. Check thread direction, thread diameter, and overall length against the original part before installation. After replacement, inspect alignment and steering linkage condition to confirm proper toe setting and joint movement.

Quality Assurance

Delphi subjects its steering components to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability in harsh service conditions. TA2236 is a standard replacement steering part engineered for OE-level dimensional and material compatibility.