Delphi TA2276 Steering Tie Rod End - Outer

Delphi TA2276 Steering Tie Rod End

Delphi TA2276 is a standard replacement steering tie rod end for front outer applications on select Chevrolet, GMC, Oldsmobile, and Isuzu vehicles. Built with OE-focused dimensional and material analysis, it is made to match the steering geometry and service requirements of the original part.

Key Features

• Black, coated finish with steel housing and steel tie rod material
• Pre-greased design with grease fitting included for serviceability
• Dust boot included to help protect the joint from contamination
• Male-to-male, straight tie rod end design
• Greaseable construction with threaded stud type
• Mounting hardware included
• Front outer position application

Product Details

The Delphi TA2276 steering tie rod end is engineered for direct replacement use in steering systems that require a straight, outer tie rod end. It features a coated steel housing, chloroprene rubber dust boot, plastic bearing material, and a pre-greased, greaseable design for routine service. Delphi subjects its steering components to extreme temperature and salt-spray testing, along with dimensional and material analysis, to support OE-level fit and durability expectations. This part cross-references MOOG Chassis Products ES2249RLT and ES3462 for the same application.

Vehicle Fitment

• Fits 1995-2005 Chevrolet Blazer, Outer
• Fits 1992-2005 GMC Jimmy, Outer
• Fits 1994-2004 Chevrolet S10, Outer
• Fits 1991-2004 GMC Sonoma, Outer
• Fits 1996-2001 Oldsmobile Bravada, Outer
• Fits 1998-2000 Isuzu Hombre, Outer
• Fits 1983-1994 Chevrolet S10 Blazer, Outer
• Fits 1983-1991 GMC S15 Jimmy, Outer

Common Repair Uses

• Restores steering linkage response when the outer tie rod end is worn
• Helps correct looseness or play in the front steering system
• Addresses clunking or knocking from the front suspension and steering area
• Supports proper toe alignment after tie rod wear or replacement
• Replaces a damaged dust boot or contaminated steering joint

Installation Notes

Verify thread direction, thread size, and position before installation. Delphi TA2276 is a front outer tie rod end with clockwise thread direction on both ends, so matching the vehicle’s steering side and adjustment requirements is important during service. After installation, a professional wheel alignment is recommended to confirm steering wheel center and tire wear control. Use the vehicle application details to confirm the correct outer position for your specific model.

Quality Assurance

Delphi applies OE engineering experience to its aftermarket steering portfolio and tests components for temperature extremes and corrosion exposure. The TA2276 is built as a standard replacement part with OE-style dimensional and material checks to support proper fit on listed Chevrolet S10, GMC Sonoma, and related applications.