Delphi TA2281 Steering Tie Rod End - Outer

Delphi TA2281 Outer Tie Rod End

Delphi TA2281 is an outer steering tie rod end built for OE-style fit and steering response. It is a straight, standard replacement with a pre-greased design, grease fitting, dust boot, and mounting hardware included for service-ready installation.

Key Features

• Outer steering tie rod end for steering linkage service
• Straight design with black coated finish
• High strength steel housing and steel tie rod material
• Pre-greased with grease fitting included for maintenance access
• Dust boot included with chloroprene rubber construction
• Standard replacement grade with threaded stud design
• Clockwise thread direction on both ends
• End 1 thread diameter: 14.0 mm; End 2 thread diameter: 12.0 mm

Detailed Description

Delphi TA2281 is engineered for outer steering applications where precise linkage movement and durable construction matter. Delphi applies OE-level dimensional and material analysis to help ensure proper fitment and consistent steering performance, and the part is tested across extreme temperature and corrosion conditions to support long-term service in demanding environments. This part cross-references MOOG Chassis Products ES2912RL for the same application.

Compatible With 1988-1997 Oldsmobile Cutlass Supreme, outer; 1988-1996 Pontiac Grand Prix, outer; 1988-1994 Buick Regal, outer; and 1990-1994 Chevrolet Lumina, outer. Delphi TA2281 is a direct-fit steering tie rod end for these outer steering positions, including Buick Regal, Pontiac Grand Prix, and Chevrolet Lumina applications.

What It Helps Address

• Loose or imprecise steering feel at the outer linkage
• Clunking or play from a worn tie rod end
• Uneven tire wear caused by steering geometry wear
• Steering response issues from damaged dust boot or joint wear
• Corrosion-related service failure in exposed steering components

Installation Notes and Tips

Verify thread direction, thread diameter, and position before installation. This outer tie rod end is non-adjustable, so alignment should be checked after replacement. Inspect the mating steering components for wear before final assembly, and confirm the dust boot seats correctly to help protect the joint.

Quality Assurance

Delphi backs this steering component with OE-focused engineering and validation. The part is subjected to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability and corrosion resistance in real-world service conditions.