Delphi TA2293 Steering Tie Rod End - Outer

OE-Style Outer Tie Rod End

The Delphi TA2293 steering tie rod end is a standard replacement outer tie rod end built for the 1999-2002 Nissan Quest. It combines OE-focused dimensional analysis with materials selected for steering precision, corrosion resistance, and long-term durability.

Delphi TA2293 is engineered for direct replacement service on the outer steering linkage and is built to match OE fit and function for the Nissan Quest.

Key Features

• Fits 1999-2002 Nissan Quest, outer position
• Pre-greased with a grease fitting included for serviceability
• Dust boot included to help protect the joint from contamination
• High strength steel housing with coated finish
• Straight tie rod end design with threaded stud construction
• Clockwise thread direction on both ends
• Standard replacement part for steering repair work
• Delphi TA2293 cross-references Beck/Arnley 101-4721 and Dorman Premium TO69315XL for the same application

Detailed Description

Delphi TA2293 is an outer steering tie rod end for the Nissan Quest, covering 1999, 2000, 2001, and 2002 models. It is built with a steel tie rod, high strength steel housing, plastic bearing material, and a chloroprene rubber dust boot to support consistent steering response and joint protection. Delphi’s OE-based engineering approach includes dimensional and material analysis to help maintain proper compatibility with the original steering system. The part is pre-greased, greaseable, and supplied with mounting hardware, making it a practical replacement for worn steering linkage components. If you are searching for a 1999-2002 Nissan Quest outer tie rod end, Delphi TA2293 is a direct-fit service part for that application.

Common Problems This Part Can Help Address

• Excessive steering play at the outer linkage
• Clunking or looseness from a worn tie rod end
• Uneven tire wear caused by steering geometry issues
• Loose or imprecise steering feel
• Boot damage that allows contamination into the joint

Installation Notes and Tips

Confirm the outer position and thread specifications before installation. Delphi TA2293 uses a 14.0 mm end 1 thread diameter and a 12.0 mm end 2 thread diameter, with clockwise thread direction on both ends. After installation, a professional alignment is recommended to restore correct toe settings and steering wheel position. For Nissan Quest steering repair, verify the existing linkage condition and replace any worn related components as needed.

Quality Assurance

Delphi applies OE-focused testing and material validation to its steering portfolio. This tie rod end is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and for corrosion exposure through extended salt spray testing. Those checks support consistent performance in demanding steering service conditions.