Delphi TA2367 Steering Tie Rod End - Inner

Delphi TA2367 Front Inner Tie Rod End

Delphi TA2367 is a standard replacement steering tie rod end built for front inner applications on select Nissan trucks and SUVs. It combines OE-based dimensional analysis with materials and testing aimed at consistent steering response and proper fitment.

Key Features

• Front inner steering tie rod end for select Nissan Frontier and Nissan Xterra applications
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint from contamination
• Steel housing and steel tie rod construction with coated finish
• Threaded stud design with mounting hardware included
• Straight, non-adjustable replacement part
• Delphi part number TA2367

Detailed Description

Delphi TA2367 is engineered as a standard replacement steering tie rod end for the front inner position. It uses a steel housing, steel tie rod material, and a chloroprene rubber dust boot, with a pre-greased, greaseable-free design for simplified service. Delphi applies OE-focused dimensional and material analysis to help ensure proper compatibility with the original steering geometry and aftermarket replacement requirements. This part cross-references MOOG Chassis Products ES3660 for the same application.

Compatible With 1998 Nissan Frontier, inner from 09/1997; 1999-2004 Nissan Frontier, inner; and 2000-2004 Nissan Xterra, inner. If you are replacing a worn front inner tie rod end on a Nissan Frontier or Nissan Xterra, Delphi TA2367 provides a direct-fit steering service part for these listed applications.

What It Helps Address

• Loose or vague steering feel from a worn inner tie rod end
• Excessive play in the front steering linkage
• Uneven tire wear caused by steering component wear
• Clunking or knocking noises from the front steering system
• Steering alignment issues related to worn linkage components

Installation Notes and Tips

Verify thread direction, thread diameter, and overall dimensions before installation. Delphi TA2367 is a front inner, straight tie rod end with a female end 2 and threaded stud design, so confirm it matches the original steering linkage configuration on the vehicle. After installation, a professional wheel alignment is recommended to restore proper steering geometry.

Quality Assurance

Delphi subjects steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. The brand also uses OE-level dimensional and material analysis to support fit and performance consistency across its aftermarket steering portfolio.