Delphi TA2382 Steering Tie Rod End - Inner

Delphi TA2382 Front Inner Tie Rod End

Delphi TA2382 is a standard replacement steering tie rod end for the front inner position. It is built with a steel housing and steel tie rod construction, pre-greased for service-ready installation, and finished with a coated black exterior for corrosion resistance.

Fits 2004-2011 Mazda RX-8, inner. This Delphi TA2382 tie rod end is engineered for direct replacement use on the Mazda RX-8 front inner steering linkage.

Key Features

• Part number: TA2382
• Front inner steering tie rod end
• Adjustable straight design
• Steel housing and steel tie rod material
• Pre-greased; grease fitting not included
• Mounting hardware included
• Black coated finish
• Male end 1 and male end 2 configuration

Product Details

Delphi applies OE-focused dimensional and material analysis to its steering portfolio so the aftermarket part matches the original application as closely as possible. TA2382 uses a straight, adjustable layout with clockwise thread direction at both ends, a 16.0 mm end 1 thread diameter, a 14.0 mm end 2 thread diameter, and a 1.5 thread pitch at end 2. The bearing material is Polyoxymethylene (POM), and the assembly is supplied as a standard replacement for front inner steering service.

For fitment-based searches, this part is listed for 2004-2011 Mazda RX-8 inner steering applications. If you are replacing a worn Mazda RX-8 inner tie rod end, Delphi TA2382 provides the correct steering linkage format for that vehicle range. This part cross-references Beck/Arnley 101-5658 for the same application.

Common Problems This Part Can Address

• Excessive steering play from a worn inner tie rod end
• Clunking or looseness in the front steering linkage
• Uneven tire wear caused by steering geometry wear
• Steering wheel wander or poor on-center feel
• Failed or corroded steering joint components

Installation Notes and Tips

Inspect the full front steering system before installation, including the outer tie rod ends, boots, and alignment settings. Because this is an adjustable steering component, a professional wheel alignment should be performed after replacement. Verify thread direction, thread diameter, and inner position match the vehicle before installation on the Mazda RX-8.

Quality Assurance

Delphi tests steering components across extreme temperature and corrosion conditions, including sub-zero cold, high heat, and extended salt-spray exposure. TA2382 is backed by Delphi OE-focused engineering and material validation for consistent aftermarket replacement performance.