Delphi TA2390 Steering Tie Rod End - Right Outer

OE-Style Front Right Outer Tie Rod End

Delphi TA2390 is a standard replacement steering tie rod end for the front right outer position on select Kia Sportage and Hyundai Tucson models. It is built with OE-focused dimensional and material analysis to support proper steering geometry and consistent fitment.

Fits 2005-2010 Kia Sportage, right outer. Fits 2005-2009 Hyundai Tucson, right outer. Delphi TA2390 is pre-greased, includes a dust boot, and comes with mounting hardware for service replacement work.

Key Features

• Part number: TA2390
• Steering tie rod end for front right outer applications
• Standard replacement design
• Pre-greased and non-greaseable
• Dust boot included with chloroprene rubber material
• Steel housing and steel tie rod construction
• Coated black finish
• Clockwise thread direction on both ends
• Mounting hardware included
• OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation

Detailed Description

Delphi TA2390 is engineered as a steering tie rod end for the front right outer location on 2005-2010 Kia Sportage and 2005-2009 Hyundai Tucson models. The bent steel design, threaded stud, and coated housing support direct replacement service where precise steering response and alignment retention matter. Delphi applies OE-level analysis to match dimensions and materials closely to the original part, helping maintain proper steering linkage operation on these vehicles. This part cross-references MOOG Chassis Products ES800036 for the same application.

Common Repair Applications

• Steering play or looseness at the front right outer tie rod
• Uneven tire wear related to worn steering linkage components
• Clunking or knocking from the front suspension and steering area
• Alignment instability after tie rod wear or replacement
• Restoring steering response on Kia Sportage and Hyundai Tucson models

Installation Notes and Tips

Verify the front right outer position before installation and confirm thread direction, thread diameter, and stud dimensions against the removed part. After installation, perform a professional wheel alignment to set toe and steering wheel position correctly. Inspect the inner tie rod, boots, and related steering components at the same time to avoid repeat service.

Quality Assurance

Delphi validates this steering component through temperature cycling, corrosion exposure, and dimensional checks to support OE-style performance in aftermarket service. The brand’s OE engineering background is applied to its steering portfolio for consistent replacement quality.