Delphi TA2412 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End

Delphi TA2412 is a front right outer steering tie rod end for select Toyota 4Runner models. Built as a standard replacement part, it follows OE dimensions and material analysis to support proper steering geometry and consistent fit on the vehicle.

Fits 1996-2002 Toyota 4Runner, right outer. This Delphi TA2412 tie rod end is built for the steering linkage on the front right side and is a direct replacement choice for worn outer steering components.

Key Features

• Front right outer steering tie rod end
• Standard replacement design for OE-style fitment
• Pre-greased for service-ready installation
• Dust boot included to help protect the joint
• Coated steel housing and steel tie rod construction
• Male-to-male configuration with threaded stud design
• Mounting hardware included
• Clockwise thread direction on both ends

Detailed Description

Delphi TA2412 is engineered for steering systems that require a bent tie rod end with precise dimensional compatibility. Delphi applies OE-focused testing and material analysis to its aftermarket steering portfolio, including exposure to extreme temperatures and salt spray, to help validate durability in demanding road conditions. The part includes a chloroprene rubber dust boot, plastic bearing material, and a coated finish to support long-term service in the steering linkage.

For Toyota 4Runner owners replacing a worn front right outer tie rod end, TA2412 provides the correct geometry for the 1996-2002 model years. This part cross-references MOOG Chassis Products ES3547 and Mevotech Supreme MES3547 for the same application.

What This Part Helps Address

• Loose or vague steering feel from a worn outer tie rod end
• Front-end play caused by joint wear
• Uneven tire wear related to steering linkage wear
• Steering noise from a deteriorated dust boot or joint
• Alignment issues after replacing steering components

Installation Notes and Tips

Install TA2412 on the front right outer position only. Verify thread direction, stud fitment, and overall length before installation, then perform a professional wheel alignment after replacement. Because this part is pre-greased and greaseable hardware is not included, it is ready for installation without adding grease fittings.

Quality Assurance

Delphi uses OE-based engineering, dimensional checks, and material analysis to support aftermarket steering fitment. The part is tested for temperature extremes and salt-spray exposure to help confirm durability in real-world service.