Delphi TA2447 Steering Tie Rod End - Left Outer

OE-Style Front Left Outer Tie Rod End

Delphi TA2447 is a steering tie rod end for the front left outer position on select Volvo and Land Rover applications. Built as a standard replacement part, it uses OE-focused dimensions and materials to support precise steering response and consistent alignment retention.

Key Features

• Fits the front left outer steering position
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Adjustable design for alignment setup
• Threaded stud type with clockwise thread direction
• Mounting hardware included

Detailed Description

Delphi TA2447 steering tie rod end is engineered for OE-level fit and function in the front suspension and steering system. Delphi applies dimensional and material analysis to match the original part as closely as possible, helping maintain proper steering geometry and dependable connection between the steering linkage and wheel assembly. This part number is commonly used on Volvo S60, Volvo V60, Volvo XC60, Volvo S80, Volvo XC70, Volvo V70, and Land Rover LR2 applications where a front left outer tie rod end is required.

Delphi tests steering components under extreme temperature and corrosion conditions, including sub-zero cold, high heat, and extended salt spray exposure, to evaluate durability in demanding road environments. If you are replacing a worn Delphi TA2447 on a Volvo S60 or Volvo XC60, this standard replacement tie rod end is built to support accurate steering feel and alignment service.

This part cross-references MOOG Chassis Products ES800848 for the same application.

What It Helps Fix

• Loose or vague steering feel
• Front-end play caused by worn tie rod joints
• Uneven tire wear related to steering linkage wear
• Steering wheel off-center after suspension service
• Clunking or knocking from the front steering linkage

Installation Notes and Tips

Install on the front left outer position only and verify thread direction, stud size, and alignment settings before service. Because the part is pre-greased and does not use a grease fitting, no routine greasing is required. An alignment check is recommended after installation to restore proper toe settings and steering wheel position.

Quality Assurance

Delphi backs this steering component with OE-focused engineering, including temperature, corrosion, and dimensional validation to support consistent aftermarket performance. The part is built to match the original application requirements for Volvo and Land Rover steering service.