Delphi TA2480 Steering Tie Rod End - Left Outer

Delphi TA2480 Front Left Outer Tie Rod End

Delphi TA2480 is a standard replacement steering tie rod end built for front left outer applications on select Hyundai and Kia vehicles. It combines OE-focused dimensional control with a coated steel housing, pre-greased construction, and a dust boot to support consistent steering response.

Key Features

• Fits 2006 Hyundai Elantra, left outer
• Fits 2007-2012 Hyundai Elantra, left outer
• Fits 2010-2013 Kia Forte, left outer
• Fits 2010-2013 Kia Forte Koup, left outer
• Fits 2012-2013 Kia Forte5, left outer
• Steel tie rod material with coated finish and black exterior
• Pre-greased, non-greaseable design with no grease fitting
• Dust boot included with chloroprene rubber boot material
• Clockwise thread direction at both ends
• Mounting hardware included

Detailed Description

The Delphi TA2480 steering tie rod end is engineered as a standard replacement for the front left outer position. Delphi applies OE-level dimensional and material analysis to help maintain proper fit between the original steering geometry and the aftermarket part. This tie rod end uses a steel housing and steel tie rod construction, a bent profile, and a coated finish for added surface protection. It is pre-greased, sealed with a dust boot, and does not require a grease fitting or routine greasing.

For Hyundai Elantra, Kia Forte, Kia Forte Koup, and Kia Forte5 applications, TA2480 supports the steering linkage at the outer end where precise movement matters. The threaded stud design, 14.0 mm end 2 thread diameter, and 10.0 mm end 1 thread diameter help match the specified OE-style fitment. This part cross-references MOOG Chassis Products ES800229 and Beck/Arnley 101-5869 for the same application.

What This Part Helps Address

• Loose or vague steering feel at the front left outer tie rod location
• Clunking or play caused by worn steering linkage joints
• Uneven tire wear related to steering toe instability
• Steering pull or wandering from worn outer tie rod components
• Restoration of proper steering response after suspension service

Installation Notes and Tips

Install Delphi TA2480 at the front left outer steering position only on the listed Hyundai and Kia applications. Verify thread direction, stud dimensions, and alignment settings before final assembly. Because this part is pre-greased and non-greaseable, no grease fitting service is required after installation. A professional wheel alignment is recommended after replacing any tie rod end.

Quality Assurance

Delphi tests steering components across extreme temperature and corrosion conditions, including sub-zero cold, high heat, and extended salt-spray exposure, to support OE-style durability in aftermarket use. The TA2480 is built using Delphi’s OE-focused steering expertise for consistent fit and performance on the specified vehicles.