Delphi TA2504 Steering Tie Rod End - Inner

Delphi TA2504 Front Inner Tie Rod End

Delphi TA2504 is a standard replacement steering tie rod end built for the front inner position. It is engineered with OE-focused dimensional and material analysis to support proper fit and steering response on select Ford Fiesta applications.

Fits 2014-2018 Ford Fiesta, inner. Fits 2011-2013 Ford Fiesta, inner, male threads.

• Front inner steering tie rod end for select Ford Fiesta models
• Adjustable straight design with male threads on both ends
• Steel housing and steel tie rod construction with coated finish
• Pre-greased for initial service readiness
• Mounting hardware included
• Black finish with no grease fitting and no dust boot

Product Details

Delphi TA2504 is built as a standard replacement steering component for the front inner linkage. The part uses a straight, adjustable design with 14.0 mm thread diameter at both ends, clockwise thread direction, and a 1.5 thread pitch on the end 2 side. Its steel housing and steel tie rod construction are paired with a coated finish for durability in everyday driving conditions. The bearing material is Polyoxymethilen (POM), and the unit is pre-greased from the factory.

This part cross-references Mevotech Supreme MS40722 and MOOG Chassis Products EV800903 for the same application. Delphi TA2504 is a direct-fit steering tie rod end choice for Ford Fiesta front inner service where the original part matches the listed thread and position details.

What It Helps Address

• Loose or vague steering feel at the front end
• Excessive play in the inner steering linkage
• Uneven tire wear caused by worn steering components
• Clunking or knocking from the steering system
• Restoring proper toe adjustment after tie rod wear

Installation Notes

Verify thread direction, thread diameter, and inner position before installation. This part is listed for front inner use on 2014-2018 Ford Fiesta and 2011-2013 Ford Fiesta with male threads. After installation, a professional wheel alignment is recommended to set toe and confirm steering geometry.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to its steering portfolio and subjects parts to extreme temperature and corrosion testing, including sub-zero and high-heat exposure plus extended salt spray testing. That validation supports consistent fit and service performance for the Delphi TA2504.