Delphi TA2555 Steering Tie Rod End - Right Outer

Delphi TA2555 Steering Tie Rod End

Delphi TA2555 is a front right outer steering tie rod end built for OE-style fit and steering response. It is a direct replacement for select Ford E-250 and E-350 applications, including Ford E-250 Econoline and Ford E-350 Econoline Club Wagon models.

Key Features

• OE-focused steering tie rod end for the front right outer position
• Pre-greased with a grease fitting included for serviceability
• Dust boot included to help protect internal components
• High strength steel housing with a coated finish
• Steel tie rod construction with threaded stud design
• Standard replacement grade with mounting hardware included
• Clockwise thread direction on both ends
• Cross-references MOOG Chassis Products ES3202R and Mevotech Supreme MES3202R for the same application

Detailed Description

Delphi applies OE engineering and dimensional analysis to its steering portfolio so the aftermarket part matches the original application as closely as possible. TA2555 is a bent, non-adjustable tie rod end with a 14.0 mm end 2 thread diameter, 18 threads per inch on end 1, and a 1.5 mm pitch on end 2. The gray, coated housing uses high strength steel, while the dust boot is made from chloroprene rubber (CR) to help protect the joint from contamination. This part is used on Ford E-250, Ford E-350 Super Duty, Ford E-350 Econoline, and Ford E-350 Econoline Club Wagon front steering systems where a right outer tie rod end is required.

Vehicle Fitment

• Fits 2003-2006 Ford E-250, right outer.
• Fits 2003-2005 Ford E-350 Club Wagon, right outer.
• Fits 1999-2005 Ford E-350 Super Duty, right outer.
• Fits 1992-2002 Ford E-250 Econoline, right outer.
• Fits 1992-2002 Ford E-350 Econoline Club Wagon, right outer.
• Fits 1992-1998 Ford E-350 Econoline, right outer.

What This Part Helps Address

• Loose or wandering steering feel at the front right wheel
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering response issues from damaged ball-and-socket joints
• Contamination-related wear when the dust boot is compromised

Installation Notes and Tips

Confirm the vehicle position before ordering, since TA2555 is for the front right outer location only. Verify thread direction, thread diameter, and stud style against the original part before installation. After replacement, a professional wheel alignment is recommended to restore proper steering geometry on Ford E-250 and Ford E-350 applications.

Quality Assurance

Delphi tests steering components for temperature extremes below -40 degrees C and above 120 degrees C, and exposes parts to 720 hours of salt spray during validation. That testing, along with OE-based dimensional and material analysis, supports consistent fit and durability for this steering tie rod end.