Delphi TA2556 Steering Tie Rod End - Left Outer

Delphi TA2556 Front Left Outer Tie Rod End

Delphi TA2556 is a standard replacement steering tie rod end built for front left outer applications. It is engineered with OE-focused dimensional and material analysis to support proper fit and steering response on select Ford Contour, Mercury Cougar, and Mercury Mystique models.

Key Features

• Front left outer steering tie rod end
• Fits 1997-2000 Ford Contour, left outer
• Fits 1999-2002 Mercury Cougar, left outer
• Fits 1997-2000 Mercury Mystique, left outer
• Pre-greased design for service-ready installation
• Dust boot included to help protect the joint from contamination
• Steel housing and steel tie rod construction
• Coated gray finish for added surface protection
• Bent style with threaded stud design
• Mounting hardware included

Detailed Description

The Delphi TA2556 steering tie rod end is built as a standard replacement part for the front left outer steering position. Delphi applies OE-level testing and material analysis to its steering portfolio, including exposure to extreme temperatures and salt spray, to help verify durability and dimensional consistency. This part is a direct-fit option for 1997-2000 Ford Contour, 1999-2002 Mercury Cougar, and 1997-2000 Mercury Mystique models with a left outer steering application. This part cross-references MOOG Chassis Products ES3470 for the same application.

What This Part Helps Address

• Loose or imprecise steering feel at the front left outer wheel position
• Clunking or play caused by wear in the tie rod end joint
• Uneven tire wear related to steering linkage wear
• Steering pull or wandering from a worn outer tie rod end
• Contamination entering the joint through a damaged dust boot

Installation Notes and Tips

Verify the vehicle application by year, make, model, and steering position before installation. This part is specified for the front left outer position; refer to the vehicle application tab for exact placement. The tie rod end uses male and female threaded ends with clockwise thread direction, so confirm thread pitch and diameter against the original component before assembly. A professional alignment is recommended after replacement to restore proper steering geometry.

Quality Assurance

Delphi uses OE-focused engineering, dimensional checks, and material analysis to support fit and performance consistency. The part is tested for harsh temperature extremes and salt-spray exposure as part of Delphi’s steering component validation process.