Delphi TA2564 Steering Tie Rod End - Right Outer

Delphi TA2564 Front Right Outer Tie Rod End

Delphi TA2564 is a standard replacement steering tie rod end for the front right outer position. It is built with OE-focused dimensional and material analysis to help maintain proper steering geometry on supported Chevrolet, GMC, Saab, Isuzu, Buick, and Oldsmobile applications.

For drivers searching for a front right outer tie rod end for a Chevrolet Trailblazer, GMC Envoy, or Saab 9-7x, this Delphi part number TA2564 provides a direct-fit service solution with pre-greased construction and a dust boot included.

• Standard replacement steering tie rod end for the front right outer position
• Pre-greased for service-ready installation
• Dust boot included to help protect the joint from contamination
• Steel housing and steel tie rod construction with coated finish
• Bent design with threaded stud type
• Clockwise thread direction on both ends
• Mounting hardware included
• Black finish

Fitment and Application Details

Compatible with 2003-2009 Chevrolet Trailblazer, right outer; 2003-2009 GMC Envoy, right outer; 2005-2009 Saab 9-7x, right outer; 2003-2008 Isuzu Ascender, right outer; 2004-2007 Buick Rainier, right outer; 2003-2006 Chevrolet SSR, right outer; 2003-2006 Chevrolet Trailblazer EXT, right outer; 2003-2006 GMC Envoy XL, right outer; 2004-2005 GMC Envoy XUV, right outer; and 2003-2004 Oldsmobile Bravada, right outer.

For 2002 Chevrolet Trailblazer, 2002 Chevrolet Trailblazer EXT, 2002 GMC Envoy, 2002 GMC Envoy XL, and 2002 Oldsmobile Bravada, this part applies to right outer applications with 16mm threads. Delphi TA2564 is also a fitment match for owners replacing a worn front right outer tie rod end on these platforms.

What This Part Helps Address

• Loose or vague steering feel
• Clunking or play from the front suspension steering linkage
• Uneven tire wear caused by worn steering joints
• Steering wheel wander or poor directional stability
• Failed dust boot or contaminated tie rod end joint

Installation Notes and Quality

Verify thread size, side, and position before installation. This part uses male ends, a 16.0 mm end 2 thread diameter, a 14.0 mm end 1 thread diameter, and a 1.5 mm end 2 thread pitch. It is a non-adjustable bent tie rod end with a plastic bearing material and chloroprene rubber dust boot.

Delphi applies OE-level testing to its steering portfolio, including exposure to extreme temperatures below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray testing. The brand also uses dimensional and material analysis to support OE-to-aftermarket compatibility. This part cross-references MOOG Chassis Products ES3676 for the same application.